User manual NOKIA WIRELESS HEADSET HDW-3

[. . . ] User's Guide for the Wireless Headset (HDW-3) 9233191 Issue 1 DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product HDW-3 is in conformity with the provisions of the following Council Directive: 1999/5/EC. A copy of the Declaration of Conformity can be found from http://www. nokia. com/phones/declaration_of_conformity/. Copyright © 2004 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia is a registered trademark of Nokia Corporation. [. . . ] (In standby mode, the headset is switched on but no call is in progress. ) When the battery is running out of power, the headset beeps and the red indicator light starts to blink. Charge the battery as described above. Changing the battery When the operating time is noticeably shorter than normal, it is time to buy a new battery. Open the battery door by gently sliding it backwards (1). 8 Getting started 3. Detach the battery from the connector (3). 4. Attach the new battery to the connector. 5. Place the connector in the space reserved for it and set the battery into its place (4). 9 English 2. Remove the battery by pulling the strap (2). Getting started 6. Close the battery door and make sure it is properly locked in place (5). Switching the headset on or off To switch on: Press and hold the power key for 2 seconds. The headset beeps and the green indicator light starts blinking fast. The blinking continues slower after the headset is connected to your phone. To switch off: Press and hold the power key for 2 seconds. The headset beeps and the red indicator light is displayed briefly. Taking the headset into use for the first time 1. Make sure that your phone is switched on. Enter the Bluetooth menu of your phone and make sure that the Bluetooth feature is activated. 10 Getting started The phone searches for all Bluetooth devices within about 10 meters and displays them as a list. Enter the passcode 0000 to associate ("pair") and connect the headset to your phone. If you do not pair the headset with the phone within 5 minutes, it will power off, when pairing the headset for the first time. Once you have entered the passcode, your phone becomes the default phone for the headset, if the headset has not been previously paired with another phone. See also Using the headset with several phones on page 18. The headset beeps and appears in the phone menu where you can view the Bluetooth devices that are currently paired with your phone. Start using the headset (see page 14). 11 English 4. Enter the submenu where you can set the phone to search for Bluetooth devices, and start the search. Getting started Adjusting the headset to your ear The headset can be worn on either ear. For optimal fit, choose between the different-sized earloops provided in the sales package. [. . . ] · Use the battery only for its intended purpose. Never use any charger or battery that is damaged. 20 Battery information · Leaving the headset in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C (59°F and 77°F). A headset with a hot or cold battery may not work temporarily, even when the battery is fully charged. [. . . ]