User manual NOKIA WIRELESS PLUG-IN CAR HARDSFREE HF-6W

[. . . ] Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. 2 The contents of this document are provided "as is". [. . . ] Check with the manufacturers of other devices to determine their compatibility with this device. 7 English should be within 10 meters of each other. Connections can be subject to interference from obstructions, such as walls, or other electronic devices. Getting started 2. Getting started Note that there may be restrictions using Bluetooth wireless technology in some locations. Check with your local authorities or service provider. 8 Getting started Overview English 9 The headset contains the following parts, as shown in Figure 1. Figure 1 Getting started Note: Parts of the headset are magnetic. Metallic materials may be attracted to the headset, and persons with a hearing aid or a pacemaker should not hold the headset to the ear with the hearing aid or close to the pacemaker. Always secure the ear piece in its holder, because materials may be attracted by the earpiece. Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased. Power key (1): Switches the headset on and off. Press the power key briefly to mute or unmute the ongoing call. Answer/end key (2): Answers or ends the call. This key can also be used for voice dialing, redialing, and switching an active call between the headset and the compatible phone. The fully charged battery has power for up to 7 hours of talk-time or up to 180 hours of standby time. (In the standby mode, the paired headset is switched on but no call is in progress. ) When the battery is running out of power, the headset beeps, and the red indicator light starts to blink. Charge the battery as described above. 16 Getting started Switching the headset on or off To switch on, press and hold the power key for 2 seconds. The headset beeps and the green indicator light starts blinking fast. The blinking continues slower after the headset is connected to your phone. To switch off, press and hold the power key for 2 seconds. The headset beeps, and the red indicator light is displayed briefly. Pairing the headset with a compatible phone 1. Enter the Bluetooth menu of your phone, and make sure that the Bluetooth feature is activated. Enter the submenu where you can set the phone to search for Bluetooth devices, and start the search. Enter the passcode 0000 to associate ("pair") and connect the headset to your phone. In some phones you may need to make the connection separately. [. . . ] If left unused, a fully charged battery will lose its charge over time. Temperature extremes can affect the ability of your battery to charge. 28 Battery information Do not short-circuit the battery. Accidental shortcircuiting can occur when a metallic object such as a coin, clip, or pen causes direct connection of the positive (+) and negative (-) terminals of the battery. (These look like metal strips on the battery. ) This might happen, for example, when you carry a spare battery in your pocket or purse. [. . . ]