User manual NOKIA XPRESS-ON-GPS SHELL

[. . . ] Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Java is a trademark of Sun Microsystems, Inc. The information contained in this user guide was written for the Nokia Xpress-on Fun shell product. Nokia operates a policy of ongoing development. [. . . ] 8 Selecting a language for the application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . In addition to this user guide, read the user guide of your Nokia 3220 phone, which provides important safety and maintenance information. When the Nokia Xpress-on Fun shell is installed on the Nokia 3220 phone, it may not be possible to use the phone with some enhancements. The Nokia Xpress-on Fun shell takes its power from the phone battery. Note that using the shell may drain the phone battery faster. 5 English 1. Installation Note: Before removing the cover, always switch off the power from your phone and disconnect the charger and any other device. Avoid touching electronic components while changing the covers. Always store and use the device with the covers attached. For general instructions on changing the back and front cover of your Nokia 3220 phone, see the user guide that came with it. To install the Nokia Xpress-on Fun shell and its connector: 1. Remove the original back cover of your Nokia 3220 phone and insert the connector supplied with the shell into the corresponding slot in the phone. 6 Installation 2. When the image is complete, press Options, and select Display to show it in the air. While drawing, you can do the following: · To move the cursor, use the scroll keys. Alternatively, press 2 to move up, 4 to move left, 6 to move right, or 8 to move down. 9 English The actual invoice for calls and services from your service provider may vary, depending on network features, rounding off for billing, taxes and so forth. Using the Wave message application · If the entire image does not fit in the editing screen, you can select the area to be edited by moving the red-bordered selection frame to the right or left in the smaller screen. · To select the drawing mode, press Options, and select Change mode and then Draw (to draw a line) or Normal (to draw a single dot). The drawing mode indicator is shown at the top left corner of the display. When Normal is selected, you can draw a dot or change the color of the current dot by pressing 5. When Draw is selected, you can press 5 to lift the pen (to move the cursor) or to put it down (to continue drawing). · To activate the eraser, press Options, and select Change mode and Erase. While using the eraser, you can lift it (to move the cursor) or put it down by pressing 5. · To fill a closed area, press Options, and select Change mode and Fill. Move the cursor to the desired area and press 5 to fill it. [. . . ] To remove the text, press Options and select Undo. Using the Wave message application Showing a previously created wave message in the air Start the Wave message application, and select the folder (Archive or Templates) where the wave message is saved. Scroll to the desired message, and press Display in the Templates folder, or press Options and select Display in the Archive folder. If you want to edit or delete a message saved in the Archive folder, press Options, and select Edit or Delete. Viewing instructions about using the application Start the Wave message application, and select Instructions and the desired topic. Changing the application settings Start the Wave message application, and select Settings. You can select the sound that is played while you show a message in the air (Sound list), adjust the sound volume, or switch the sound on or off. [. . . ]