User manual NORCENT DP2700 QUICK START

[. . . ] QUICK OPERATION SHEET DVD Receiver Receiver DP2700 STEP 1: Following the diagram below, connect the Yellow, White and Red cables from the back panel of the DVD player directly to the Television correspondingly* Activating P/I (Progressive/Interlace) Mode If your TV has component input terminals (YPRPB or YCbCr), you can connect your TV to this DVD player's component output terminals (YPRPB) using component signal cables (not provided). [. . . ] This Norcent DVD Player may be operated either by the buttons on the unit's front panel or by the included remote control. STEP 3:Switch your TV into video input mode. This will be usually a button on your TV remote that is labeled INPUT or TV/VIDEO, Line Input, AV Input or Source. If you have trouble to locate the Video Input Mode button, please consult your TV operation manual. STEP 4: Press the STANDBY/ON button located on front panel of Home theater. STEP 8: Insert the two included "AAA" batteries into remote control. Make sure + and - on batteries match up with + and - inside remote battery compartment. STEP 9: Point remote control at remote sensor located on front panel of player. Note: The remote control is operational at a maximum distance of 21' from sensor at an angle up to 30 either side. PROG SOU RCE STEP 5: Press " OPEN/CLOSE " button. STEP 6: Place disc on tray with playback side face down. 30 30 PROG SOU RCE STEP 7: Press " OPEN/CLOSE" button. [. . . ] * If your TV doesn't have Video Cable Input, you need to purchase a RF Modulator from your local electronics retailer. [. . . ]