Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual NOVAK THE DIG. We hope that this NOVAK THE DIG user guide will be useful to you.
Lastmanuals help download the user guide NOVAK THE DIG.
Manual abstract: user guide NOVAK THE DIG7-2009 SETUP GUIDE
Detailed instructions for use are in the User's Guide.
[. . . ] a) Apply a small amount of throttle to confirm that both front and rear speed controls are functioning properly. Position the AUX switch to the left or the right to illuminate the red front indicator LED (Fig. 1, #6). This position should also illuminate the red LED on board the Dig Unit. [. . . ] Referring to Figure 1, the blue LED corresponds to #5 and the red LED corresponds to #6.
(FIGURE 2)
ONE-TOUCH PROGRAMMING
Before programming Novak's One-Touch Setup for the Dig Unit, both front and rear ESCs need to be set up either simultaneously or individually. Be sure to follow manufacturer's set-up procedures for the ESCs carefully. Before turning on your vehicle's electronics, make sure that your transmitter's throttle position and the AUX switch or dial are both in the NEUTRAL position. PRESS and HOLD the Dig Unit's One-Touch button. CONTINUE TO HOLD the Dig's One-Touch button UNTIL THE RED LED TURNS ON, releasing the button AS SOON AS THE LED TURNS RED. Move the AUX switch or dial to one end position, and hold it there until the green status LED TURNS SOLID GREEN. Move the AUX switch or dial to the opposite end position, and hold it there until the green status LED BLINKS GREEN. When the green light stops blinking, the Dig Unit is programmed. Return the AUX switch or dial to NEUTRAL.
THE DIG SETUP PHOTO
Refer to Figure 1 for the following steps. Using one signal harness, connect the AUX output (usually CH. 4) of the receiver to the AUX input (Fig. Using the other signal harness, connect the Throttle output (CH. 2) of the receiver to the Throttle input (Fig. Connect the signal harness from the rear ESC to the rear output (Fig. [. . . ] · All Rights Reserved · No part of these instructions may be reproduced without the written permission of Novak Electronics, Inc. · The Dig: Electronic Dig Unit for Dual System Crawlers is a trademark of Novak Electronics, Inc.
+
HARNESS INSTRUCTIONS
TRANSMITTER ADJUSTMENTS
+
5 6
1. 2) input from receiver Output to rear ESC Output to front ESC LED harness indicator (blue) for rear ESC LED harness indicator (red) for front ESC On-board (red) LED indicator for front ESC (also used with One-Touch Set-Up) 8. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE NOVAK THE DIG
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual NOVAK THE DIG will begin.
