User manual NOVAK XXL FM RECEIVER

[. . . ] With a small standard screwdriver, press on each of the three metal locking tabs on the sockets until the wires are easy to remove. Remove wires. RECEIVER OPERATION MANUAL 2. With the screwdriver, carefully lift each of the metal locking tabs to the angle shown. 3. Sockets should "click" into place. [. . . ] Futaba style connectors will fit into the XXL without modification or wiring sequence change. JR, Hitec, new-style KO, and Airtronics Z connectors will fit into the XXL without modification or wiring sequence change. However, you MUST be sure that the brown wire on the JR, and the black wire on the Hitec, new KO, and AirZ harnesses are closest to the outside/left edge of the case. This section describes how to properly mount the receiver and avoid damage due to vibration or shock. Electric Cars & Boats­­Mount the XXL with the included double-sided tape as close to the antenna as possible, where the receiver's case will not contact the chassis or other rigid surfaces. Gas Cars & Boats­­The XXL should be mounted in foam rubber and protected from fuel and water. Do not use glue to mount the receiver! 3. Tubular Plastic Antennas­­Run the antenna wire up through the plastic antenna tube and let the excess wire trail out the top of the tube. Rigid Antennas­­Wrap antenna wire around the mast with 1/4" spacing. Shrink wrap or tape the top to secure the wire and let the excess trail off the top. Do not cut or coil excess wire­­Range will be reduced! STEP 4 HOOK-UP INSTRUCTIONS 1. INSTALL MOTOR CAPACITORS Electric motors generate radio noise that can cause radio interference. Included are three 0. 1 µF (50V) non-polarized, ceramic capacitors. These capacitors must be installed on every motor to help reduce the noise generated by the motor and also to prevent possible damage to the speed control. Solder 0. 1 µF (50V) capacitors between: · POSITIVE (+) motor tab & NEGATIVE (-) motor tab. · POSITIVE (+) motor tab & GROUND tab*. · NEGATIVE (-) motor tab & GROUND tab*. *If your motor does not have a ground tab, solder the capacitor leads to the can of the motor as shown below. Negative (-) motor tab 0. 1 µF Capacitors Schottky diode Positive (+) motor tab Ground / motor can STEP 5 DSC CONNECTION Futaba, Sanwa, and JR DSC cords can all be used with the XXL receiver's BAT/DSC input slot without modifications. Refer to the manufacturer's operating instructions for details on using the DCS cord feature. SERVICE PROCEDURES Before sending your receiver for service, review the TroubleShooting Guide and instructions. The receiver may appear to have failed when other problems exist. PLEASE NOTE: Receivers that operate normally when received will be charged a minimum service fee and return shipping charges. WHAT TO SEND: Fill out all of the information requested on the enclosed RECEIVER SERVICE CARD (also available on our website) and return it with your receiver. WARRANTY WORK: For warranty work, you MUST CLAIM WARRANTY on the RECEIVER SERVICE CARD and include a valid cash register receipt with purchase date on it, or an invoice from previous service work. If warranty provisions have been voided there will be a service charge. SERVICE COSTS: Customer is responsible for all service costs (parts, labor, and shipping/handling charges). See RECEIVER SERVICE CARD for payment and shipping options. [. . . ] OPTIONAL USE OF EXTERNAL BATTERY PACK A 4 or 5-cell external receiver battery pack can be used if erratic radio operation is experienced during hard acceleration. Consult your ESC's operation manual for proper installation and usage. The external battery pack's plug inserts into the XXL with the positive (+) wire in the middle and the negative (-) wire towards the outside edge of the case. FCC APPROVAL NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]