User manual NOVATION SUPERNOVA II

[. . . ] 1 - Keypad Section 4 This section contains all the buttons used to select sounds. 1-E 0 ffects Section 2 BACK PANEL SPDIF out in out in pedal/switch 3 thru midi out in 8 aux 3 7 6 aux 2 5 4 aux 1 3 2 master 1 input/sw2 input/sw1 (sustain) phones OI 1 2 3 4 5 6 7 8 9 This section contains all the knobs and buttons associated with the Effects section. This switch turns the mains power supply in the Supernova II keyboard on and off. Edited and newly-created Programs or Performances that have not been written into a memory location will be lost when the Supernova II keyboard is switched off. [. . . ] In the Filter section there are 5 pages available. These are selected using the Page Up and Page Down buttons to the left of the display. There are a maximum of 2 parameters displayed on any page. The upper and lower Data knobs on the right of the display are used to alter these parameter's values. Page 1 looks like so: Fq Mwh LFO2 amt Res Mwh LFO2 amt +63 +63 The higher parameter is "Fq MWh LFO2 amt". This parameter determines how the Modulation Wheel affects the amount of Modulation of the Cutoff Frequency of the Filter from LFO 2. When the upper Data knob is set to +00, there is no change to the Filter Cutoff Frequency when the Modulation Wheel is engaged. Anticlockwise of +00, there will be an increasing amount of Negative modulation. The Filter will be closed more by LFO 2 when the Modulation Wheel is engaged. Clockwise of +00, the modulation is Positive. The Filter will be increasingly opened by LFO 2 when the Modulation Wheel is engaged. The range of this parameter is -64 to +63. This parameter is memorised with a Program. The lower parameter is "Res MWh LFO2 amt". This parameter determines how the Modulation Wheel affects the amount of Modulation of the Resonance of the Filter from LFO 2. When the lower Data knob is set to +00, there is no change to the Filter Resonance when the Modulation Wheel is engaged. Anticlockwise of +00, there will be an increasing amount of Negative modulation. The Filter will be made less Resonant by LFO 2 when the Modulation Wheel is engaged. Clockwise of +00, the modulation is Positive. The Filter will be increasingly made more Resonant by LFO 2 when Modulation Wheel is engaged. The range of this parameter is -64 to +63. This parameter is memorised with a Program. 89 FILTER SECTION Page 2 looks like so: Fq AT LFO2 amt Res AT LFO2 amt +63 +63 The higher parameter is "Fq AT LFO2 amt". [. . . ] Utilise power outlets that are on different branch (Circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/re orient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorised to distribute this type of product. [. . . ]