User manual NUMARK DM2002X

[. . . ] Professional Disc Jockey Products DM2002X STEREO MIXER OWNER'S MANUAL DM2002X NUMARK INDUSTRIES 11 Helmsman Road, North Kingstown, RI 02852 http://www. numark. com DM2002X CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE ANY COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL ONLY. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this appliance. 7. [. . . ] "Clipping" is when the power amplifier is distorting and working beyond it's limits. Amplifier distortion is THE major cause of speaker failure. · To prevent fire or shock hazard, do not expose the unit to rain or moisture. Never place cans of beer, soda, glasses of water or anything wet on top of the mixer! A NOTE ON CABLES: Make the input and output connections with readily available low-capacitance stereo cables. Quality cable makes a big difference in audio fidelity and punch. See your Numark dealer or an electronics or audio specialist store if you are not sure which cables to get. Numark - The Proven Leader in DJ Technology ©1997 Numark Industries 5 http://www. numark. com DM2002X DM2002X FRONT PANEL DIAGRAM. . . GUIDED TOUR OF FEATURES AND OPERATING INSTRUCTIONS. . . If the D M 2 0 0 2 X is your first mixer, please read this entire manual before you begin operation. If you are an experienced DJ we recommend reading the manual so you may fully appreciate this newer technology. The D M 2 0 0 2 X can be 10" rack-mounted or used as a freestanding unit. Keep in mind that there are a few features you may never have seen before in a mixer of this type that you will need to read about. INSTALLATION AND OPERATION Study the Connections Diagram on page 13. First, connect all stereo input sources. Next connect your microphone(s) and monitor headphones. Make sure all faders are at "zero" and the unit is off. Finally, connect the stereo outputs to the power amplifier(s) and/or audio sources. Now you are ready to switch it on. 14 6 5 3 1 2 4 7 17 18 9 15 13 12 11 CHANNEL FEATURES 1. Channels 1, 2, & 3 Rotatable Input Toggle Switches select which source will be live to that channel based on what you have connected to the rear panel input section. To rotate lift of toggle and place in it's new position or to replace unplug the old unit and plug in the new one. The Input Faders are low-noise, low-impedance, high-quality, smooth AlpsTM faders. These control individual source levels in the mix. The P F L pushbuttons are used to route channel audio to the main volume meter and the Cue Monitor Section. When a PFL is pressed the main volume meter changes its display to the PFL channel. This allows the DJ to accurately match levels before mixing with that channel's gain control. [. . . ] Connect headphones with a standard 1/4" stereo plug. The P F L audio is sent to the headphone amp using the PFL Assign Pushbutton and the PGM Mix control. Use this to allow line level equipment to be plugged into your phono inputs giving you a total of 5 line input options. Warning: make sure the LINE/PHONO input switch is set to line before playing any line input level devices through your mix 1. [. . . ]