User manual NUMARK ICDX

[. . . ] Make sure all items listed on the front of this guide were in the box. Make sure all devices are turned off and all faders and gain knobs are set to their lowest level. Connect all stereo input sources as indicated in the diagram, your microphone, and headphones Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources. Switch everything on in the following order: · Finally, turn on any amplifiers or output devices When turning off, always reverse this operation by, · Finally, turn off any audio sources. [. . . ] Several menus and options can be accessed by holding down one of the buttons listed below and turning the parameter knob. Holding the SCRATCH button and turning the parameter knob will allow you to choose the desired scratch mode: Vinyl: This mode allows you to use the platter to scratch just like you would with a vinyl record. When you press on the inner part of the jog wheel, the music will stop where it is until the wheel is released. Forward: When you use the jog wheel to scratch, only the forward motions are heard. This simulates using a crossfader to cut out the backspins. Bleep: Allows you to "insert" a scratch while the music continues to advance. One you are done scratching, the music will continue to play where it would have been if you hadn't scratched. bleep Forward: Essentially a combination of Bleep and Forward scratch modes. Allows you to "insert" a scratch but only plays the forward motion of the platter. cue: Scratches from the current cue point. Each time you touch the inner platter, the song will begin from the current cue point. This allows you to set a cue point for a certain segment of a song and scratch repeatedly over the same segment. cue Forward: Cue forward is a combination of Cue mode and Forward mode. It scratches from the current cue point but does not play sound during counter clockwise motion of the wheel. Search speed can be adjusted by holding SEARCH and rotating the parameter knob. Options based upon 1 wheel rotation are 15 seconds, 30 seconds, and 1 minute. Holding the PROGRAM button and turning the parameter knob will bring you to the following menu options. Pressing down on the parameter knob will allow you to modify the parameters for the menu option that you have selected: Next Track Fade Time (On, Off, 1s, 2s, 3s): Turning this option on will allow you to automatically fade from one track to the next. If you select "On", you will then be prompted to enter the desired fade time from 1 to 3 seconds. scratch Delay (On , Off): Activates a slight delay when releasing the platter in scratch mode. Remote (On-On, On-Off, Fader Start): Changes the remote start option to allow the unit to be started by another device using a remote start cable. Power On Play (On, Off): When on, this option will cause the CD player to begin playing as soon as the power is turned on. [. . . ] When disconnecting a USB device from the iCDX, always make sure to use the SOURCE (SRC) button to switch to CD/MP3 mode before disconnecting. Make sure that the letters "HD" are not blinking on the display when disconnecting a USB device. Disconnecting a USB device while the iCDX is in USB MASTER mode could possibly cause data on the USB device to become corrupted and unreadable. After disconnecting an Apple iPod, you must wait until the iPod has returned to its main menu before you reconnect it to the iCDX or it may not be recognized by the iCDX. [. . . ]