User manual NUMARK MPCD33

[. . . ] MPCD33 PROFESSIONAL DUAL CD PLAYER MANUAL ©2002 Industries http://www. numark. com MPCD33 SAFETY INSTRUCTIONS a) b) c) d) e) f) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings on this product and in these operating instructions should be followed. Follow Instructions - All operating and other instructions should be followed. [. . . ] BPM ­ is lit when BPM is being displayed 20. MP3 ­ indicates when a CDR with MP3 files is inserted in the player - The Leader in DJ Technology ©2002 Numark Industries -7- http://www. numark. com MPCD33 REAR PANEL FEATURES 22. Control Cable Connector- Plug in the 8-pin cable included in here to connect the remote control and main CD unit together 23. IEC Power Plug Connector - Plug your supplied power cord in here. Voltage Selector - Set this switch to the voltage for your location. RCA Audio Connectors - Connect your CD player to your mixer from this line level output. Digital Output - The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In order to use the digital output you should not use variable pitch slider and the pitch bend buttons. If you adjust the pitch, other devices may not read the digital output properly because the sampling rate changes 27. Remote Start Connector ­ Use this connector to plug into your fader start compatible mixer or remote switch. To use this connector for fader start, connect the supplied fader start cable to a fader start compatible mixer. Every time you move the crossfader on the mixer over to the side that the unit is on, it will automatically start playing. When you move the fader away from that side, the unit will stop. Moving the fader back to the unit side will start play again. There are two potential modes associated with the switch PLAY-CUE and PLAY/PAUSE. This means that when the unit is remotely stopped it will go back to the cue point automatically. To change modes hold down the time button for 3 seconds and the display will flash the play " " and pause " " icons. In PLAY/PAUSE mode, moving the crossfader away from the unit side pauses right where it is, and resumes when the fader is brought back to the unit. To change modes back to PLAY-CUE hold down the time button for 3 seconds and the display will flash the play " " and cue " " icons in the display. Remote Assignment Switch - Set this switch in the position for the method of remote start you will be using. Foot switches are often used for creative mixing techniques and can be found in most music shops. Connector plugs are often ¼" and an adapter to 1/8" will be needed for connection. [. . . ] If NUMARK determines that any mixer is not covered by this Limited Warranty, purchaser must pay all parts, shipping, and labor charges for the repair or return of such mixer. What are the limits on NUMARK'S liabilities?THE WARRANTIES GIVEN IN THIS LIMITED WARRANTY, TOGETHER WITH ANY IMPLIED WARRANTIES COVERING NUMARK MIXERS, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, NUMARK SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL, CONSEQUENTIAL, INDIRECT OR SIMILAR DAMAGES, LOSS OF PROFITS, DAMAGES TO PURCHASER'S PROPERTY, OR INJURY TO PURCHASER OR OTHERS ARISING OUT OF THE USE, MISUSE OR INABILITY TO USE ANY NUMARK MIXER, BREACH OF WARRANTY, OR NEGLIGENCE, INCLUDING BUT NOT LIMITED TO NUMARK'S OWN NEGLIGENCE, EVEN IF NUMARK OR ITS AGENT HAS BEEN ADVISED OF SUCH DAMAGES, OR FOR ANY CLAIM BROUGHT AGAINST PURCHASER BY ANY OTHER PARTY. [. . . ]