User manual NUTONE ALLURE WS3 RANGE HOOD

[. . . ] Heat oils slowly on low or medium settings. Always turn hood ON when cooking at high heat or when cooking flaming foods. Grease should not be allowed to accumulate on fan or filter. Always use cookware appropriate for the size of the surface element. [. . . ] Damper flap must open freely in direction of airflow (away from range hood). TIES To accomodate off-center ductwork, the Damper/Duct Connector can be installed up to 1-inch on either side of hood center or the 7" Round Duct Plate can be installed up to ½" on either side of hood center. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp. Remove the Blower Wheel by rocking it side to side and applying a slight force to pull wheel from motor. Slide the ring onto the Small Diameter End of the wheel and down to the Stop Edge of the wheel. Make sure Tab on wheel fits into one of the Motor Slots. Push wheel down until it is locked in place. Cut the Ties, lift plate out, and discard plate. WARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel. Lock or tag service panel to prevent power from being switched on accidentally. Use a piece of Cardboard to protect the cooktop, if necessary. Slide hood towards wall until mounting screws are engaged in narrow end of (4) Keyholes. Use Duct Tape to make joints secure and air tight. Connect house black to hood black wire, house white to hood white wire, and house ground under Green Ground Screw. Replace filters, turn on power at service panel, and test for proper operation. If hood is to be installed Non-Ducted: Purchase a set of (2) Non-Ducted Filters from your local distributor or retailer and attach them to the aluminum mesh filters. nOTE: For models that are installed in the non-ducted mode , the most effective operation is achieved at speeds 1 and 2. These speeds provide the most efficient and quiet operation during cooking, while maximizing the benefits of the recirculating filtration system. If it is not open (blown), additional diagnostics need to be done. Re-assemble air chute, light wire harness, bottom panel, and filters. Turn on power and check hood/control operation. WARNING: To reduce the risk of electric shock, disconnect from power supply before cleaning. [. . . ] tHIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions. the duration of an implied warranty is limited to the one-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you. [. . . ]