User manual OKI B930N SETUP GUIDE

[. . . ] Do not let the drum sit in room light for more than 5 minutes. Fold the handle (3) down and slide the image drum Cartridge into the printer. Adjust the paper guides for the paper you are using. [. . . ] Close the duplex unit cover Remove the access cover from the back of the printer (1), connect the duplex unit interface Lift the duplex Unit until the upper hooks are latched in the printer. Guide needs to be moved from the body of the printer up to the exit module. If the duplexer is installed, the guides from the printer itself must be moved to the duplexer exit module. The guides are two pieces of rubber and plastic that assist in stacking to the top of the printer. When installing the horizontal transport this Connect finisher power cord to the printer accessory power connection. Level the finisher making it parallel to the printer. Move the catch to the right and insert the staple module. Slide the drawer out and remove the packing material, then close the drawer. Insert the punch waste container and fully seat it. Connect the feeder power cord into the printer accessory outlet. Remove the backing from the Velcro® strip on the back of the Handy Reference Guide and mount it on the side of the printer. Turn the Printer ON and wait for the print server status light to stop blinking. Keep these sheets handy: they contain information you need to set up the printer on your network. Be sure to use only the power cable supplied with your printer! [. . . ] Note: Refer to the Network section in the User's Guide if the web page does not appear after carrying out steps 1 and 2: 1. Enter the printer's IP address or URL in the address input column on the web browser and press the <Enter> key. Test the Driver Install To make sure the printer driver is correctly installed, print a page from any program. [. . . ]