User manual OKI COLOR 8N SETUP GUIDE

[. . . ] Make wastethe drive coupling onthe toner box is lined up with coupling on the printer. 4 Close the side panel. 1 Remove toner waste box from packaging. 2 Pull the latch and open the side panel. Remove any blue shipping retainers. 3 Put the toner waste box into the printer as shown. Press down, then swing the box into the printer and release. Drive Couplings ! 2 Our quality assurance department tests every unit before it is shipped. As a result, you may notice a small amount of toner in this part of the printer. | OKICOLOR 8 3 Install the Oil Roller 4 Remove the shipping tape from the blue levers. [. . . ] The PostScript Printer Description (PPD) setup screen appears. 6 Click Auto Setup to have the Adobe Printer Driver configure your printer automatically OR Click Select PPD to select a PPD file manually. 7 Follow the instructions on your screen to finish. The Demo page prints. Setup Guide | 7 11 Calibrate the Color This is an important process to make sure your OKICOLOR 8 gives you sharp, accurate color images. There are two parts: 1 Color Registration, and 2 Color Balance. Setting the Color Registration Since each color is printed separately, you must set the color registration to ensure that the colors line up properly. If the colors are out of alignment, the printed page will appear blurry and unclear. To ensure optimum print quality, you should set the color registration on a routine basis (once a month or so). We also recommend that you set the color registration when you change image drums, or if you move the printer. Windows 95/98/NT4. 0 Open the Color Registration Utility. 1 Click Start ® Programs ® OKICOLOR 8 ® OKICOLOR 8 Color Registration Utility. 2 Make sure OKICOLOR 8 ( or OKICOLOR 8 PS) on LPT1: is highlighted in the box (if you are using a port other than LPT1, make sure that port is highlighted). 3 From the list, select the tray you want to calibrate. Go to Step 4 to continue. Windows and Macintosh 4 Click Print Color Calibration page. The printer prints a test page with 9 sections, each with a series of lined boxes in it. Lined Boxes Lined Box Numbers Section #1 List Box Macintosh Open the Color Registration Utility. 1 In the OKICOLOR 8 Folder, double-click OKICOLOR 8 Color Registration Utility. 3 From the list, select the tray you want to calibrate. Go to Step 4 to continue. 5 Beginning with section #1, find the lined box where the least amount of color shows in the spaces between the black lines and note its corresponding number. one has no color, !If more thancolor, boxto zero. lightestthe select the one closest If all boxes have select the one, nearest zero. 8 | OKICOLOR 8 6 On the screen, find the corresponding box (in this case, #1--yellow, left) and enter the number you noted on the calibration page. Windows Setting the Color Balance Windows and Macintosh color !Be sure to check your printer's color registration before you use the balance utility. [. . . ] Press: In Menu Mode sets displayed menu item as the user default. Press: Changes printer status from on line to off line. Press: Enters the Paper Size Quick Menu. Hold: Prints a listing of the current and default menu settings. [. . . ]