User manual OKI OKIFAX 4100

[. . . ] 4100 Fax ENGLISH 15/1/97 9:37 am Page 1 OKIFAX 4100 Handbook English 4100 Fax ENGLISH 15/1/97 9:37 am Page 2 Every effort has been made to ensure that the information in this document is complete, accurate and up-to-date. The manufacturer assumes no responsibility for the results of errors beyond its control. The manufacturer also cannot guarantee that changes in products made by other manufacturers and referred to in this handbook will not affect the applicability of the information in it. This handbook is subject to change without notification. [. . . ] occur at a later date, press the No Using the numeric keypad, enter the date on which you wish the transmission to begin. Using the numeric keypad, enter the time on which you wish the transmission to begin. Tip: Be sure to enter the time using a 24-hour clock (i. e. , 8:00 a. m. would be entered as 08:00, and 8:00 p. m. would be entered as 20:00). 5 6 7 8 Sending a Delayed Fax from the Document Feeder 1 2 Load your documents. 9 Press the Yes key and the display will show BROADCAST/MEMORY TX or FEEDER TX depending on the User Function 18 setting. If the display shows FEEDER TX go to step 10. If the Advanced Operations 41 English Advanced Operations 4100 Fax ENGLISH 15/1/97 9:37 am Page 42 English display shows BROADCAST/MEMORY TX press No key, display will show FEEDER TX. Refer to the following instructions. To Select Using A One Touch key An Auto Dial number Do This Press the One Touch key. Press the Auto Dial key, then enter the two digit Auto Dial number on the numeric keypad. Dial as you would on a normal telephone. 6 7 Press the Yes key. Using the numeric keypad, enter the time on which you wish the transmission to begin. Tip: Be sure to enter the time using a 24-hour clock (i. e. , 8:00 a. m. would be entered as 08:00, and 8:00 p. m. would be entered as 20:00). A number dialed on the numeric keypad 8 11 Press the Start key. Your fax machine will begin waiting for the time and date you have set before sending the fax. Sending a Delayed Fax From Memory Press the Yes key and the display will show BROADCAST/MEMORY TX or FEEDER TX depending on the User Function 18 setting. If the display shows BROADCAST/MEMORY TX go to step 10. If the display shows FEEDER TX press No key, display will show BROADCAST/MEMORY TX. 9 1 2 3 4 Load your documents. The display will show DELAYED TX and today's date. If the transmission is to occur today, press the Yes key and go to step 7. occur at a later date, press the No Using the numeric keypad, enter the date on which you wish the transmission to begin. 10 Select a location. Refer to the instructions below. To Select Using A One Touch key An Auto Dial number Do This Press the One Touch key. Press the Auto Dial key, then enter the two digit Auto Dial number on the numeric keypad. Dial as you would on a normal telephone. A number dialed on the numeric keypad 5 11 Press the Yes key to confirm your selection. [. . . ] Only one OKIFAX 4100 should be connected between any series connected apparatus and the PSTN. Difficulties may occasionally be experienced when making calls from other apparatus connected to the PSTN via the series apparatus. Such difficulties may include: (i) Difficulty in making calls (ii) Problems in telephone conversion being experi enced by both parties to the call (iii) Such that any apparatus which forms part of the RBS or is connected via it, is so connected that no signals of any kind may be conveyed between that apparatus and a PSTN circuit or vice-versa, except by means of other apparatus that does not material ly affect the electrical conditions presented to one another by that apparatus and the PSTN. Further information is contained in the proposed British Standard for RBS to PSTN lines. [. . . ]