User manual OKI OKIPAGE 10EX ACCESSORY INSTRUCTION GUIDE

[. . . ] Apple, LaserWriter, Macintosh, and EtherTalk are registered trademarks of Apple Computers, Inc. Year 2000 Compliance All products currently sold by Oki Data are Year 2000 Compliant. Each product contains information technology that accurately processes date and time data between the years 1999 and 2000, and carries no issue for the September 9, 1999 (9999) programming concern. [. . . ] Operating instructions for the Image Creator and NetFlash utilities are located on the CD included in this kit. 4 | OKI Flash SIMM Installing Flash Overview Memory in the OKIPAGE® 10i, 10i/n, 10e, 10ex, 12i and 12i/n Printers For models listed above, the flash memory SIMM is installed on one of the following optional accessory boards. · 1 MB Memory Expansion Kit (Part # 70033101) · RS-232C Serial Interface Kit (Part # 00025302) · OKILAN® 310e Network Interface Kit (OKIPAGE 10i only) (Part # 70032901) · OKILAN® 310e+ Network Interface Kit (OKIPAGE 12i only) (Part # 70032902) If your printer is not equipped with one of these accessories, you will need to purchase the accessory to install the Flash SIMM in the printer. Expansion sockets are provided on each board included in the option kits. Preparing Your Printer !SIMMs and circuit boards can be damaged by static electricity and rough handling. Keep the SIMM card and option board in the packaging until you're ready to perform the installation. To avoid damage to the SIMM card, ground yourself by touching the chassis of your computer each time before handling. Disconnect printer from power before beginning installation procedure. 1 Turn the printer off and unplug the power cord. 3 If an option board is already installed in your printer, turn the screws counterclockwise, then slide the board out of the printer. Hardware Installation Guide: English | 5 Removing the Access Plate If you are installing an option board for the first time: a. Turn the printer around so the rear is facing you. access plate Installing the SIMM Card Install the Flash SIMM card in the SIMM 2 socket on the option board. 1 Place the option board on a flat surface. Use a screwdriver to pry the plate from the back panel of the printer. bottom 2 Remove the SIMM card from its packaging. 3 Hold the SIMM card with the metallic contact edge down, and the notch on the bottom. 4 Insert the metallic contact edge of the SIMM card into the SIMM 2 socket at a 45° angle. 6 | OKI Flash SIMM 5 Push in until the metallic contacts are fully inserted into the socket. [. . . ] Keep board in packaging until you're ready to install it. SIMMs are sensitive to static electricity. [. . . ]