User manual OKI OKIPOS 406

[. . . ] Federal Communications Commission Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] In other words, recovery will be attained automatically when paper is set in the printer and the cover closed after printing has stopped if the parameter has been set to cease printing. (1) Test Printing Turn the power on while holding the FEED button depressed. When the FEED button is depressed at the time of the end of test printing, only the characters will be printed out repeatedly. (2) Hexadecimal Dump Mode Open the printer cover, then turn the power on while holding the FEED button. When the cover is closed, "*** HEX DUMP PRINTING ***" is printed, and the printer enters the Hexadecimal Dump Mode. Each of the signals sent from the computer to the printer will be printed out in hexadecimal code. This function allows you to check if a control code sent to the printer by the program being used is correct or not. The final line is not printed if its data is less than one full line. However, if the FEED button is pushed, the final line is printed. To turn off the mode, it is necessary to turn off the printer completely. Be sure to use roll paper that matches the printer's specification. 5 mm width, install the optional paper roll holder as described on the following page. Cover open lever Roll paper 2) While observing the direction of the roll, set the paper roll into the hollow, and pull on the leading edge of the paper toward you. Note: When using a paper roll with an 57. 3) Push down both sides of the printer cover to close. Note: Make sure that the printer cover is securely closed. 4) Tear Bar Model: Tear off the paper as shown. Auto Cutter Model: If the printer cover is closed after turning on the power, the cutter operates automatically and the front end of the paper is cut. There is a cutter inside the paper outlet slot. Not only should you not put your hand in the paper outlet slot while printing is in progress, never put your hand into the outlet even when printing is not in progress. The printer cover can be opened when replacing the paper. However, since the cutter blade is on the inside of the printer cover, be careful not to place your face or hands too close to the cutter blade. [. . . ] Switch 1-3 on the tear bar model is set at [OFF], and the others are set at [ON]. The functions of switches 1-2 through 1-8 will change according to the command emulation that has been set using switch 1-1. (1) Star mode Switch 1-1 Function Command emulation Should not be changed (Should be set to on) Auto cutter Sensor adjustment Pin #31 (INIT) reset signal Handshaking conditions (conditions for BUSY) 1-7 1-8 Automatic status back function Should not be changed (Should be set to on) Valid Invalid Valid Offline or receive buffer full Invalid Valid Invalid Valid Invalid Receive buffer full ON Always ON OFF Switch 1-1 1-2 1-3 1-4 1-5 1-6 1-7 1-8 Function Command emulation Graphic adjustment Auto cutter Sensor adjustment Pin #31 (INIT) reset signal Handshaking conditions (conditions for BUSY) Automatic status back function Should not be changed (Should be set to on) 203 DPI Valid Invalid Valid Offline or receive buffer full Invalid Valid ON Always OFF 180 DPI Invalid Valid Invalid Receive buffer full OFF The factory settings of DIP switch 2 are all on. All factory settings for dipswitch 1 on the auto cutter model are set at [ON]. [. . . ]