User manual OLIMPIA SPLENDID AQUARIA

[. . . ] Any other use not recommended by the manufacturer may cause fire, electric shock or injury. The appliance is not intended to be used by persons with reduced physical, sensorial or mental capacities (including children), or with lack of experience or knowledge, unless they have been supervised or instructed in the use of the appliance by a person in charge of their safety. Children must be supervised to ensure they do not play with the appliance. To reduce the risk of electric shock, this plug must be used in an appropriate socket. [. . . ] 14 The heater must never be positioned immediately below an electrical socket. 15 Do not use this heating appliance with programmers, timers or any other device that switches the appliance on automatically, as a fire risk may ensue if the appliance is covered or incorrectly positioned. 11 Do not use the heater in the immediate vicinity of a bathtub, shower or pool. 16 This appliance is designed to be used solely to heat domestic and similar environments, according to the instructions given in this manual. 17 The user must not leave the appliance unsupervised while it is plugged in. 18 Do not touch the appliance with wet hands or feet. 19 Do not leave the appliance exposed to atmospheric agents (sun, rain, etc. 20 Should the appliance be dropped or run badly, unplug the electric cord immediately. Check that no parts are damaged before switching back on: in case of doubt contact a qualified technician. 21 Do not pull the power cable or the appliance itself to remove the plug from the socket. This product is CE marked to denote compliance with Directives 73/23/EEC (Low Voltage) and 89/336/EEC (Electromagnetic Compatibility). In this operating mode the internal fan is always on and the required fan speed can be selected at any time by pressing key SW3 on the control panel. Minimum speed Maximum speed Starting in stand-by mode, this mode can be selected by pressing SW2 twice and these 3 symbols The temperature set-point (set temperature) can be adjusted between 2°C and 35°C with variations of 1°C by means of SW4/SW5, and the relative value appears on the control panel display (D1). If the room temperature is below the set temperature, the heater switches on at minimum heating power (fig. 5) with ventilation at minimum speed until the set temperature is reached. While the appliance is running at minimum heating power, the set temperature can be changed at any time. Starting in stand-by mode, this mode can be selected by pressing SW2 three times and these 3 symbols The temperature set-point (set temperature) can be adjusted between 2°C and 35°C with variations of 1°C by means of SW4/SW5, and the relative value appears on the control panel display (D1). If the room temperature is below the set temperature, the heater switches on at maximum heating power (fig. 6) with ventilation at maximum speed until the set temperature is reached. While the appliance is running at maximum heating power, the set temperature can be changed at any time. Starting in stand-by mode, this mode can be selected by pressing SW2 four times and the automatic symbol (A) appears on the control panel display. The temperature set-point (set temperature) can be adjusted between 2°C and 35°C with variations of 1°C by means of SW4/SW5, and the relative value appears on the control panel display (D1). [. . . ] To cancel the delayed switch-on, press SW1 and the unit will start with the last selected settings. With the unit running press key SW6 to activate the switch-off timer mode (the two symbols appear on the control panel Once the appliance is switched back on after a power failure, it goes to stand-by mode. Display), then set the required delay (between 1 and 12 hours) after which the unit is to be switched off (after confirming the timer) using keys SW4 and SW5. If no key is pressed within 5 seconds, the timer setting function is automatically cancelled. [. . . ]