User manual OLIMPIA SPLENDID CALDO ALOGENA DATASHEET

[. . . ] 2) The appliance must be kept out of reach of children. 3) Warning: when using electrical appliances, basic safety precautions should always be followed to avoid the risk of fire, electric shock and injury. 6) Remove the plug from the socket if the appliance is not in use. [. . . ] 8) Alwais operate the product from a power source of the same voltage frequency and rating as indicated on the product certification plate. 10) Ensure that the cord is fully extended and not in contact with any part of the heater before use. 12) Do not place the cord under carpets or rugs and arrange it so it cannot be tripped over. 13) Do not use the heater in any areas where petrol, paint or other flammable liquids are stored e. 14) Ensure that when operating the heater it is at least 1 meter from any forniture bedding or other combustible material and do not drape clothing or other materials over it. 15) Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pools. 11) In use some parts of the heater are not so when moving, use the handle provided. 9) Do not operate the heater with a damaged cord, or plug, or after a malfunction or if the heater is damaged in any way if so return it to the supplier or their authorized agent. 16) Be sure that no other light current appliances are in use on the same electrical circuit as your heater as an over load can occur. Plate together as the following sequences: - remove the butterfly nuts from the lower part of the body frame; - insert the power cord through the slot placed in the middle part of the basement and then assemble the body frame to the base plate; - secure the body frame to the base plate by means of the two butterfly nuts previously removed; - insert the power cord through the suitable slot. That the voltage shown on the data plate corresponds to that of the mains supply, and that the socket is fitted with an efficient earth connection. In case of incompatibility between the socket and the plug on the appliance, the plug should be replaced with one of a suitable type, by a professionally qualified person, who shall ensure that the section of the plug cable is suitable for the power absorbed by the appliance. In general, the use of extension cords or adaptors is not recommended; if they are indispensible, they must comply with the safety norms in force and their current flow (in amperes) must not be less than the maximum of the appliance. 4) The appliance must not be positioned immediately below a socket. The mains socket must be easy to reach, so that, in case of emergency, the plug can be removed with ease. Do not use this heater with a programmer, timer or any other device that switches the heather on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. In the event of a fault or malfunction, switch off the appliance and have it checked by a qualified technician; repairs carried out by unqualified persons may be hazardous and void the warranty. Ensure that the unit is placed on a firm level surface so that the antioverturn switch operates correctly before using your halogen heater. [. . . ] Ensure that the unit is placed on a firm level surface so that the antioverturn switch operates correctly before using your halogen heater. Insert the power plug into a 220V50Hz power point and switch on. A) to switch on the heater and activate minimum heating power (400 W) highlighted by the central light switching on. [. . . ]