User manual OLIVETTI CMS 140 EURO ADDENDUM

[. . . ] This Operation Guide contains information that corresponds to using both the inch and metric versions of this machine. This Operation Guide shows messages of the inch version. when using the metric version , see the messages of the inch version for reference. With regard to the messages in the text, if a message has only the difference of upper- and lower-case spelling, we show only the message of the inch version. [. . . ] Be absolutely sure that the 10BASE-T or 100BASE-TX cable that you use is a shielded cable. Example of transmission modes for data scanned using the Scan System and the required software The software indicated in the thick-lined balloons is included with this product. Refer to the On-Line Manual <Functions Edition> for information on using the included utilities and other software. Turn the main switch to the scanner back ON ( | ). This section explains the procedures to set the network address for the scanner. The network address that should be set here will differ depending upon your network environment. Check with your network administrator BEFORE performing this setting. If you are using a DHCP server to set the network addresses, you will not need to change the IP address and the subnet mask because the DHCP has been enabled (ON) as the factory default setting. Use the and keys to move to select Scan default and then press the Enter key. Enter the four-digit management code using the numeric keys. The password at the factory default setting is 1800 for the 18 ppm model and 2200 for the 22 ppm model. If you change both the summer time and date/time settings, the summer time setting will be ignored. PC OS System environment CPU RAM HDD Recommended environment CPU RAM HDD CD-ROM drive Ethernet cable IBM PC/AT or compatible Windows 2000 (Service Pack 2 or later), Windows XP, Windows Server 2003 or Windows Vista Pentium 133 MHz or faster 64 MB or more 20 MB or more Celeron 500 MHz or faster 128 MB or more 300 MB or more 1 drive 10BASE-T or 100BASE-TX There are three main functions available with this network scanner. Perform the following procedure in order to install into your computer the required utility that is appropriate to the application and operating system in use in your computer. scan to PC Stores the image data of scanned originals as a file in a desired folder on your computer. Install the Scanner File Utility into the corresponding computer in order to use this function. Registration of the save folder in your computer, as well as registration in the scanner of the destination is required. For information on making settings from an Internet Web browser, as well as for each utility, refer to the On-Line Manual <Functions Edition> of this Operation Guide. For information on making settings from an Internet Web browser, as well as for each utility, refer to the On-Line Manual <Functions Edition> of this Operation Guide. TWAIN Connects to the scanner from the TWAIN-compatible application according to the procedures of that particular application. Install the TWAIN Source on the computer that contains the application in order to use this function. The following utilities are contained on the CD-ROM that is included with this product. [. . . ] Enter the password using the numeric keys and press the Enter key. If your user name is not displayed even if the and keys are pressed, use a web browser or AddressEditor to check to see if your user name has been registered. Use the and keys to move to select the desired destination. An item can be selected from Send to User PC (SEND TO USER PC), Private Book, and Common Book. [. . . ]