User manual OLIVETTI COPIA 9020

[. . . ] The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice. Your attention is drawn to the following actions that could compromise the characteristics of the product: · Incorrect installation; incorrect or improper use, or, in any case, not in accordance with the warnings given in the User Manual supplied with the product; replacement of original components or accessories with others of a type not approved by the manufacturer, or carried out by unauthorized personnel. 29 ILLUSTRATIONS Console (Section A back of cover) Basic Machine (Section B back of cover) Optional Units (Sections C/D/E/F/G back of cover) Structure of the Manual The various functioning possibilities of the photocopier are described in four different sections: BEFORE USE COPIER FUNCTIONS INDICATIONS/REFILLING/JAM CLEARANCE MAINTENANCE/ACCESSORIES/TECHNICAL DATA On the back of the cover you will find all the illustrations for the console, the components of the basic machine and the optional units. Keys The name of the keys are always followed by the letter A (which defines the graphic section) and by a reference number which identifies it on the console. [. . . ] If more than two copies of each page are to be made, all the copies of the left-hand page should be made first, and then all the copies of the right hand page. Once copying is complete, press the SEPARATION key (A-6) to activate the mode. It is possible to make copies on special media, such as OHP film, postcards and adhesive labels. Insert the special media and regulate the alignment guide according to the copy format. Close the cover of the multi-feeder and press the FEEDER key (A-23). Enter the number of copies required, using the NUMERICAL keys (A-31). Notes - When using special media such as OHP film, follow the instructions on the packaging. - Postcards (A6 format) must be feed horizontally. Position the original as shown in the figure (second side) and insert the copy in the multi-feeder upside down and positioned as shown in the figure. TONER The LED lights up when there is no toner. PAPER The LED lights up when there is no paper in the selected device (cassette, manual multi-feeder or optional LCT tray). In this case, the operator must add paper (see the section "Adding paper" on page 10). PAPER JAM The LED flashes to indicate a paper jam (see the section "Removing a paper jam" on page 11). "E" INDICATOR (Call the Technical Assistance Service) The error code "E" followed by a number on the display indicates that the copier is not operating correctly. Switch the copier off and then on again. If the problem persists, unplug the machine and call the Technical Assistance Service, notifying them of the error code. Do not insert paper beyond the maximum level. Slowly push the cassette until it clicks into position. Notes - When the no paper led flashes during a copying cycle, add the paper first and then press the PRINT key (A-30). The following parts of the copier should be cleaned weekly or when the copies become marked or unclear. Clean the glass using a cloth and a non-abrasive product, and then wipe it completely dry. Clean the surface of the cover using a cloth and a specific product for plastic materials, and then wipe it completely dry. [. . . ] Notes - The MANUAL STAPLER key flashes (green) when a jam occurs in the stapler. To remove the jammed paper, follow the instructions described in "Removing jammed staples". - The NO STAPLES INDICATOR flashes (red) when the staples run out. To add more staples, following the instructions described in "ADDING STAPLES". [. . . ]