User manual OLIVETTI D-COPIA 2000

[. . . ] The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice. The ENERGY STAR program is an energy reduction plan introduced by theUnited States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment. Your attention is drawn to the following actions which could compromise the conformity attested to above, as well as the characteristics of the product: · incorrect electrical power supply; · Incorrect installation, incorrect or improper use or use not in compliance with the warnings provided in the User's Manual supplied with the product; · Replacement of original components or accessories with others of a type not approved by the manufacturer, or performed by unauthorised personnel. No part of this material may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording or by any information storage and retrieval system, without permission in writing from the Publisher. [. . . ] When the original has been set on the platen and the scanning of the original completed, Place next original. is displayed and the Combine indicator blinks. When this occurs, carry out the following procedure. Replace the original with the next one and press [Start]. If there are no more originals, press [Combine] or [OK]. 4 in 1 Layout Order Follow the procedure below to change the order in which pages are to be laid out within the copied page when making 4 in 1 copies. The display will blink and the copier will return to the state where copying can be continued. It is possible to Collate the number of copy sets needed from multiple sheets of originals. Collate while changing the direction for each set at the time of collating can be changed using the System Menu. Input the number of sets of copies using the numeric keys. When the original has been set on the platen and the scanning of the original completed, Place next original. is displayed and the Collate display blinks. When this occurs, carry out the following procedure. Replace the original with the next one and press [Start]. If there are no more originals, press [Collate] or [OK]. Use this to make test copies or copies where high-quality printing is not required. Copy settings that are frequently used can be registered and then recalled by pressing [Program]. Input the program number (0 to 9) using the numeric keys and press the [Program] key for 3 seconds. The display of the number input will blink 2 times and the program will be registered. NOTE: If the same number as a program already registered is input, the Using programmed setting to make copies Press or , select the number of the program to be used and then press [OK]. Input can also be done using the numeric keys. The copy will be made using the program that has been set. [. . . ] Recycled paper made from 100% recycled pulp may be used with this product. Please consult with dealer or sales representative for information on the recommended types of paper, etc. This copier has various functions, which if used together, can further increase copying efficiency. 02= Switches the copier to Manual Exposure because the Photo Mode does not have Auto Exposure. [. . . ]