User manual OLIVETTI DP N40 ADMINISTRATOR GUIDE

[. . . ] DP N24, N32 and N40 Network Laser Printers System Administrator Guide PUBLICATION ISSUED BY: Olivetti Lexikon, S. p. A. Documentazione Via Jervis, 77 - 10015 Ivrea (Italy) Copyright © 1998, Olivetti All rights reserved This product's conformity with quality requirements is certified by the Mark it bears Xerox®, CentreWare DP® and all Xerox products mentioned in this publication are trademarks of Xerox Corporation®. Adobe® and PostScript® are trademarks of Adobe Systems Incorporated. PCL, HP, and LaserJet are trademarks of Hewlett-Packard Company. [. . . ] You will see: IP Address Res. Set the method used to assign the IP address, including subnet mask and default gateway. The available values are: Control Panel BOOTP/RARP DHCP* 1. Press Menu Up or Menu Down until you see: 2. Press Item Up or Item Down until you see: 3. Press Value Up or Value Down until you see: 4. You will see: 3-68 y DP N24, N32 and N40 System Administrator Guide Token Ring Menu Table 3. 14 Token Ring Menu functions (continued) Keystrokes 1. Press Menu Up or Menu Down until you see: 2. Press Item Up or Item Down until you see: 3. Press Value Up or Value Down to change the value of the character above the cursor. The value is incremented or decremented by 1 each time the key is pressed. Holding down Value Up or Value Down causes continuous scrolling through the values. To change other characters in the IP address, press Item Up or Item Down to scroll right or left respectively through the character string, then press Value Up or Value Down to change the value of the character above the cursor (as in Step 4). When you have completed setting the IP address, press Enter . You will see: Menu Item and Function IP Address Set the four byte IP address. The available values are: xxx. xxx. xxx. xxx Where xxx=000 to 255. Display Menus Token Ring Menu Token Ring Menu IP Address IP Address xxx. xxx. xxx. xxx IP Address xxx. xxx. xxx. xxx = = This item only appears if IP Address Res. For this item (after Step 3), Item Up moves the cursor to the right through the displayed IP address and Item Down moves the cursor to the left. This allows you to change characters within the string rather than having to reenter the entire string. With the cursor displayed under a character, Value Up increments the value of that character and Value Down decrements the value. IP Address xxx. xxx. xxx. xxx = Token Ring Menu IP Address Ready Table 3. 13 Page 7 of 12 Chapter 3: Using the Control Panel y 3-69 Token Ring Menu Table 3. 14 Token Ring Menu functions (continued) Keystrokes 1. Press Menu Up or Menu Down until you see: 2. Press Item Up or Item Down until you see: 3. Press Value Up or Value Down to change the value of the character above the cursor. The value is incremented or decremented by 1 each time the key is pressed. [. . . ] Never use a ground adaptor plug to connect the equipment to a power source receptacle that lacks a ground connection terminal. Never attempt any maintenance function that is not specifically described in this documentation. These are provided to prevent overheating. Never install the equipment near a radiator or any other heat source. [. . . ]