User manual OLIVETTI JET LAB 400

[. . . ] However, due to differences between individual PSTNs in the various countries, the approval does not unconditionally guarantee success operation of every PSTN termination point. If you encounter any problems, you should contact your supplier immediately. The manufacturers declare under their own responsibility that this product complies with provisions laid down by the directive 1999/05/CE. Conformance is certified by the application of the mark to the product. Network compatibility declaration This product has been designed and developed to operate in the networks of all European Community countries, and in those of Switzerland and Norway. Full compatibility with the networks of individual countries will depend on specific national software parameters which can be set in the product. [. . . ] The display shows on the top line: DOCUMENT READY and on the bottom line, the default contrast value: NORMAL. The initial resolution value is: " " (standard). If necessary, change the contrast and resolution values as described in "To adjust the contrast and resolution". The display shows: Place the document in the ADF. The display shows on the top line: DOCUMENT READY and on the bottom line, the default contrast value: NORMAL. The initial resolution value is: " " (standard). If necessary, change the contrast and resolution values as described in "To adjust the contrast and resolution". The display shows: ADDRESS BOOK CODE OR < > Dial the desired speed dialling code, for example . The display shows the digits in the fax number that you assigned to it. If the name has also been saved, the display shows the latter. Once the number has been dialled, transmission continues in the ordinary way. INCOMING CALLS |/} |/} To view the other available option: "OUTGOING CALLS". Number (and, sometimes, name) of the selected correspondent. This number corresponds to the number you dialled, only if the correspondent set his own fax number correctly. Otherwise, it may be different or not be present at all. Date and time at which the transaction was carried out. Length of transaction (in minutes and seconds). Result of the transaction: - OK: if the transaction was completed successfully. - ERROR CODE XX: if the transaction was not completed due to the cause indicated by the error code (see "Error codes", chapter "Troubleshooting guide"). TO ENABLE/DISABLE THE AUTOMATIC PRINTING OF THE BROADCAST TRANSMISSION REPORT Until the display shows: FAX SET-UP The display shows: DATE AND TIME The display shows: VARIOUS SETTINGS Until the display shows: BROADC. REP. :ON |/} To view the other available option: "BROADC. To return the fax machine to the initial stand-by mode. TO ENABLE/DISABLE THE AUTOMATIC PRINTING OF THE DELAYED TRANSMISSION DATA Until the display shows: FAX SET-UP TO ENABLE/DISABLE THE AUTOMATIC PRINTING OF THE The display shows: TRANSMISSION AND FAILED TRANSMISSION REPORT DATE AND TIME The display shows: Until the display shows: VARIOUS SETTINGS Until the display shows: FAX SET-UP The display shows: DELAY LIST: ON DATE AND TIME The display shows: |/} To view the other available option: "DELAY LIST: OFF". To return the fax machine to the initial stand-by mode. VARIOUS SETTINGS Until the display shows: FAILED TX REPORT |/} To view the other available options: "TX REPORT: ALWAYS" and "TX REPORT: OFF". FAILED TX REPORT - the fax machine will automatically print a report only after each failed transmission. [. . . ] 14400-12000-9600-72004800-2400 (with automatic "fall back") Compression method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MH, MR, MMR Error correction mode . . . . . . . . . . . . . . . . . . . . . . . . . . . Printing on plain paper, bubble ink jet printer Max. printing width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]