User manual OLYMPUS B-HLD30

[. . . ] Do not touch the contacts of the power battery holder. Clean the power battery holder by wiping it with a soft, dry cloth. Never use a wet cloth, alcohol, lacquer thinner, benzine or deterg ent. OPERATION Normal shooting and vertical shooting 1) For normal shooting, turn the camera's power ON and operate the camera as usual. 2) When vertical shooting is required, be sure to release the vertical operation lock knob. [. . . ] Do not use this product where it may be exposed to flammable gas. Doing so poses a risk of fire or explosion. Do not use or store this product where it may be exposed to high temperatures (for example, under direct sunlight, on a car dashboard, or near heating equipment) or excessive dust. Transportation and storage Do not leave the battery in the battery charging equipment or camera. Even when the power switch is set to off, a small amount of current continues to flow and may lead to a decrease in battery performance. When not using the battery, attach the provided cap and store it in a cool, dry place with a temperature between 15°C and 25°C (39°F and 77°F). When transporting or storing the battery, attach the provided cap to prevent short-circuiting of the +/- terminals. Do not put the battery in a bag or drawer with metallic objects such as jewelry or precious metals. This could cause a fire, overheating, explosion or leakage. MAIN SPECIFICATIONS Battery : One or two BLM-1 lithium ion batteries can be used. (More pictures can be taken with the power battery holder attached than with the camera alone. However, the actual number of pictures that can be taken varies depending on shooting conditions. ) : B-HLD30 : Approx. g( oz) (excluding the protective cap and batteries) Service life Battery performance degrades gradually after repeated charge and discharge. When operation time is significantly reduced, it may be time to replace the battery. Model No. Dimensions Weight CONNECTING THE POWER BATTERY HOLDER (See the illustrations above. ) A. Preparing the camera 1 Turn the camera's power OFF. 2 Open the camera's battery compartment cover on the bottom of the camera and remove the BLM-1 lithium ion battery. 3 Detach the camera's battery compartment cover from the camera. * Design and specifications are subject to change without any notice or obligation on the part of the manufacturer. 9 Do not place the power battery holder in or near fire. Never expose this product to water or moisture including rain and seawater. If battery fluid gets in your eyes, blindness may result. Rinse your eyes with clean water without rubbing them and see a doctor immediately. If a battery does not fit properly into the power battery holder, do not force it. Otherwise, fire ignition, overheating, explosion, fluid leak or damage may result. B. Preparing the power battery holder (this unit) 4 Remove the protective cap from the power battery holder. [. . . ] Letters : Postfach 10 49 08, 20034 Hamburg, Germany. Printed in Japan CN CN 4 3 6 8 5 7 9 1 2 3 4 5 6 7 8 +- 9 ! " # $ 1 2 3 4 5 6 7 8 +/- 9 ! " # $ A 3 CN 2 4 5 . - 1 A OFF B B 6 ! 7 9 8 B-HLD30 * BLM-1 . [. . . ]