User manual OLYMPUS PFL-01

[. . . ] Instruction Manual Waterproof Case PFL-01 For the electronic flash FL-20 Thank you for buying the Underwater Case PFL-01. Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong use may cause damage to the flash on the inside from water leakage, and repair may not be possible. [. . . ] Remove the Case from the water and check that no water has accumulated at the bottom of the Case. Do not perform any operation yet, but just observe. Remove the Case from the water and check that no water has accumulated at the bottom of the Case. Try operation of the buttons used frequently. If there is still no entry of water, everything is OK!As the inside can be seen, the inspection for entry of water also can be made securely!Taking photos underwater Setting the flash mode This case enables underwater TTL AUTO shooting. CAUTION : · When this case is used, the AUTO mode of the electronic flash cannot be used. Even if the mode dial of the flash is set to AUTO, it emits light at the maximum intensity. 1 Place the Case slowly into the water. At first, immerse the Case for only three seconds. Check that no water has entered into the Case. Next, check by immersing for three minutes. Now everything is all right. Underwater TTL AUTO shooting Turn the case's mode dial knob to set the electronic flash to the TTL AUTO mode. For details including the digital camera setup, refer to the camera and flash instruction manuals. 2 3 4 Underwater MANUAL shooting Turn the case's mode dial knob to set the electronic flash to the MANUAL mode. For details including digital camera setup, refer to the camera and flash instruction manuals. 5 6 CAUTION : · For the camera's iris setting and standard shooting range, refer to the flash instruction manual. · The underwater flash shooting range (distance) maybe reduced depending on the conditions at the time of shooting (clarity of the water, suspended matter, etc. ). Be sure to check the image on the camera's LCD monitor before actual shooting. 7 8 E-21 E-22 5. Handling After Shooting Wipe off any waterdrop. After underwater shooting, remove any drops of water from the case. Use pressurized air or a soft, lintfree cloth to carefully wipe away any moisture from the hinge between the front and rear lids, the TTL cable connector and the buckles. Removing the electronic flash Carefully open the case, loosen the shoe lock dial of the flash and, while holding the mode dial knob on the case firmly, slide the flash out of the case's hot shoe. CAUTION : · After opening the case, always put it down it with the CAUTION : · Especially when waterdrops remain between the front and the rear lid, they may spill to the inside when the Case is opened. Take special care to wipe off all waterdrops. · When opening the Case, take sufficient care that no water will drop from your hair or body onto the Case and the flash. · Before opening the Case, make sure that your hands or gloves are free of sand, fibers, etc. · Do not open or close the Case at locations where water or sand is to be sprayed. [. . . ] Q12: What are the model numbers of the PFL-01 accessories?A12: The following accessories are being sold. (1) O-ring for the PFL-01 body (POL-201A/ 1, 000, POL-201B/ 1, 000): This is a silicone rubber O-ring packing to be installed in the PT-019 body to make it waterproof. O-rings for other Case models cannot be used. [. . . ]