User manual OLYMPUS PT-020

[. . . ] Instruction Manual Underwater Case PT-020 For the digital camera CAMEDIA C-5060 Wide Zoom I Thank you for buying the Underwater Case PT-020. I Please read this instruction manual carefully and use the product safely and correctly. I Please keep this instruction manual for reference after reading it. I Wrong use may cause damage to the camera on the inside from water leakage, and repair may not be possible. [. . . ] If it does not move, oil or grease may have gotten on the mode dial. · When the digital camera is not used for about 3 minutes while in the shooting mode, it enters the sleep mode (standby status) and no operations are possible. To cancel sleep mode and return to operation status, press the zoom lever, shutter button or any other button. For details, refer to the digital camera's instruction manual. E-23 E-24 Final Test The final test after loading the camera is explained below. This is the only way to eliminate worry about possible entry of water!It can be performed easily in a water tank or a bathtub. The required time is about five minutes. Simple water immersion test Explanatory image Hints As the Case is transparent, waterdrops entering into it can be confirmed easily. In case of trouble with the O-ring, three seconds are enough for water to enter. Are there air bubbles coming out between the lids?Remove the Case from the water and check that no water has accumulated at the bottom of the Case. Do not perform any operation yet, but just observe. Remove the Case from the water and check that no water has accumulated at the bottom of the Case. Try operation of the buttons used frequently. If there is still no entry of water, everything is OK!As the inside can be seen, the inspection for entry of water also can be made securely!Did you remember to attach the balance weight? 4. Taking Pictures Under Water How to Use the Hand Strap Pass your hand through the accessory hand strap and adjust the length with the stop button. 1 Place the Case slowly into the water. At first, immerse the Case for only three seconds. Check that no water has entered into the Case. Next, check by immersing for three minutes. Do not forget the balance weight. 2 Take pictures carefully. Confirm the picture on the LCD monitor. This Case uses the LCD monitor to confirm the picture. [. . . ] (2) O-rings for attaching the PPO-01 standard port to the PT-020 case (POL-101/¥1, 000): Silicon rubber packing for sealing the connection between the PPO-01 and PT-020. (3) Silicone O-ring grease (PSOLG-1/¥800): This is a special grease for silicone O-ring maintenance. (4) Silica gel (SILCA-5/¥500): This is a desiccant used to prevent fogging of the glass parts of the Case. (5) LCD hood (PFUD-04/¥1, 000): This hood is installed on the LCD monitor window of the Case to make it easier to see the LCD monitor of the camera. [. . . ]