User manual OLYMPUS PT-047

[. . . ] 5mm 375g Jp PT-047 O POL-041 SILCA-5S PSOLG-2 PFUD-07 PRLC-12 PFCA-01 PSOLG-1 PSOLG-3 PTCB-E02 JP 29 MEMO En Thank you for buying the Underwater Case PT-047 (hereinafter Case). Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. Wrong use may cause damage to the camera inside the Case due to water leakage, and repair may not be possible. [. . . ] CAUTION: If a leak is detected in normal handling, do not use the Case and contact Olympus. Install the digital camera Check the digital camera Check the digital camera before loading it in the Case. Battery Confirmation The flash is used very frequently during underwater shooting. Before diving, make sure that you have enough remaining battery power. Confirmation of the Remaining Number of Pictures to be Taken Confirm that the image storage has a sufficient remaining number of pictures to be taken. Remove the hand strap from the digital camera. When a digital camera is loaded without removing the strap, the strap may get caught between the Case lids and may cause water leakage. EN 15 Open the Case 1 Slide and hold the slide lock towards the arrow direction (1 of figure below) and turn the open/close dial counter clockwise (2 of figure below). 2 Turn the open/close dial to the position where it cannot be turned further. En Open/close dial 1 Slide lock 2 Open CAUTION: Do not exert too much force while turning the open/close dial. EN 16 Load the digital camera 1 Confirm that the digital camera is OFF. 2 Gently insert the digital camera into the Case. 3 Insert 2 piling up silica gel bags (1g) between the . The silica gel bag provided for prevention of fogging. 2 En 3 CAUTION: The silica gel bag will be caught when the Case is sealed and water leakage will occur. Once silica gel has been used, the moisture absorption performance will be impaired. Always replace the silica gel when the Case is opened and closed. Make sure the camera is loaded properly Check the following points before sealing the Case. Is silica gel inserted all the way at the specified location? â· Is the O-ring attached properly to the opening on the Case? â· Is there any dirt or foreign matter on the O-ring or the O-ring contact surface on the front lid?For details of the maintenance, see "6. [. . . ] When such chemicals are used, the O-ring may be damaged or its deterioration will be accelerated. EN 26 How to Apply Grease to the O-ring Apply the exclusive lubricant to each O-ring. Make sure that your fingers and the O-ring are free of dirt, and squeeze about 5 mm of lubricant onto a finger. ) Apply the lubricant with three fingers and spread it over the ring. [. . . ]