User manual OLYMPUS STYLUS ZOOM 130

[. . . ] INSTRUCTIONS Before using your camera, read this manual carefully to ensure correct use. Thank you for purchasing an Olympus camera. Before you start to use your new camera, please read these instructions carefully to obtain optimum performance and a longer service life from the unit. Indicates circumstances under which mishandling resulting from ignoring this symbol could result in personal injury or property damage. WARNING KEEP THE BATTERIES AWAY FROM FIRE. NEVER TRY TO DISASSEMBLE, RECHARGE, OR SHORT CIRCUIT BATTERIES. NEVER ATTEMPT TO DISASSEMBLE THE CAMERA; IT CONTAINS A HIGH-VOLTAGE CIRCUIT. [. . . ] on the LCD panel. is displayed After shooting, press the button again to cancel the selftimer/remote control mode. Remote control operation is canceled automatically when not in use for more than 20 minutes. 41 2. Aim the remote control at the camera and press the button. The shutter will be released after about 3 seconds. Notes: backlit. The remote control may not work when there is inverted fluorescent light near the camera. The camera will focus on the subject directly in front of it. The remote control may not work when the subject is Use the remote control within the range shown at left. 42 USING THE REMOTE CONTROL (optional) Attaching to the Strap Open the buckle close the buckle , insert the strap , and The remote control can be attached to 5 mm (0. 12 ~ 0. 2 in) and flat straps with a and a width of 6 mm -12. 5 mm (0. 24 0. 49 in). round straps with a diameter of 3mm to thickness of 1. 2 mm ~ 2 mm (0. 05 ~ 0. 08 in) 43 Replacing the battery Replace the battery if there is no sound when the button is pressed. 1. 2. Open the buckle and remove the battery cover inside by sliding in the direction of the arrow. Attach the battery cover by sliding in the direction of the arrow and close the buckle . Insert a new battery (CR1220) with the 3. Handling Cautions Never apply excessive force to the remote control when attached to the strap. · Usable temperature range: -10°C~40°C. 44 (14°F~104°F) CORRECTING THE DATA 1. or longer. Press the MODE button for two seconds The year indication will start blinking. Do not use an instrument with a sharp tip. 2. Press the SET button to correct the year. If you press the button once, the number on the display will advance by 1. And if you keep it pressed, the numbers will run in rapid succession. 45 3. Press the MODE button again. The month indication will start blinking. 4. Repeat steps 2 and 3 to set the hour and minutes. Note: As you press the mode button, the blinking indication changes in the order of year, month, day, hour, and minute. The data correction will be finished when the mode button is pressed again. 46 PRINTING THE DATE AND TIME Choose the desired mode with the MODE button. The mode will switch in the described order by pressing the MODE button. The quartzdate uses the same power source as the main unit. Make sure to correct the data after the battery is replaced. The data is imprinted in the lower right of the picture. If there is something whitish or tinged with orange where the data is imprinted, the data may be difficult to read. The data may not be imprinted correctly on the frame(s) after the specified final exposure of the film. No data Year-month-day Month-day-year Day-month-year Day-hour-minute 47 QUESTIONS AND ANSWERS CAMERA MAINTENANCE Q: How long will the battery last?A: A new 3V lithium battery will last for roughly 15 rolls of 24-exposure film on which the flash was used on half of all the shots (determined under Olympus test conditions). If you do not use the flash and zoom very often, the battery will last much longer. A: If the flash is used continuously, it may become hot. If this happens, stop using the camera for a while. Q: Can I use infrared film? A: No, you cannot. Q: How should I clean the lens? A: Wipe the lens gently with lens cleaning tissue that has fluid. been moistened with a small amount of lens cleaning Q: Can I mount a filter or hood?Q: What should I do when both the orange and green lamps are blinking and the camera doesn't work? A: Release your finger from the flash. The camera will reactivate. 48 CARE AND STORAGE 1. 2. [. . . ] Telephoto -- 0. 9 ~ 5. 0 m (3 ~ 16. 4 ft) with ISO 400 color negative film. Flash modes: Auto (Automatic flash activation in lowlight and backlight), Red-eye Reducing (otherwise same as in Auto), Flash Off (no flash with slowest shutter speed of 4 sec. ), Fillin (forced activation), Night Scene (for night scenes with slowest shutter speed of 4 sec. other functions operate the same as in Auto), Red-eye Reducing Night Scene (otherwise same as in Night Scene). 66 Battery check: Displayed on LCD panel. Weatherproof: IEC Standard publication 529. Classification of degrees of protection provided by enclosures. [. . . ]