User manual OLYMPUS VN-750

[. . . ] Please read these instructions for information about using the product correctly and safely. Keep the instructions handy for future reference. To ensure successful recordings, we recommend that you test the record function and volume before use. The contents of this document may be changed in the future without advanced notice. [. . . ] If the fluid burns your skin, seek medical attention immediately. Keep battery out of the reach of children. If you notice anything unusual when using this product such as abnormal noise, heat, smoke, or a burning odor: 1 remove the battery immediately while being careful not to burn yourself, and; 2 call your dealer or local Olympus representative for service. When you throw away dead batteries, be sure to cover their terminals and always observe local laws and regulations. Follow these important guidelines to prevent batteries from leaking, overheating, burning, exploding, or causing electrical shocks or burns. Take precautions when carrying or storing batteries to prevent them from coming into contact with any metal objects such as jewelry, pins, fasteners, etc. Never store batteries where they will be exposed to direct sunlight, or subjected to high temperatures in a hot vehicle, near a heat source, etc. When the batteries are too weak, [ ], [LO] and [bATT] appears on the display and the recorder shuts down. " · Remove the batteries if you are not going to use the recorder for an extended period of time. Turning on the power If you set the time and date beforehand, the information will be stored automatically when the file is recorded. This function enables easier file management. " When you install batteries for the first time or each time you replace the batteries, the "hour" indicator will flash. When the "hour" is flashing, conduct the setup from step 1. You can select between 12 and 24 hours display by pressing the DISPLAY button while setting the hour and minute. If the recorder is on and stops for 5 minutes or longer, the display shuts off and it goes into power save mode. To exit power save mode, press any button. You can select the order of the "month", "day" and "year" by pressing the DISPLAY button while setting them. The recorder beeps to alert you of button operations or warn you of errors. When you change the setting for the time and date or beep sound, remove the battery and then repeat the above steps 1 through 4. To record a meeting or a lecture clearly, select [SP]. [. . . ] In addition, carefully check the remaining battery level in order to ensure that the battery will not run out while processing. While the recorder is during stop mode or playback mode, pressing the DISPLAY button will make the display switch information in the following order: 1 While the recorder is during stop mode, pressing and holding the STOP (4) button will make the display switch information in the following order: 1 Q1: The power cannot be turned on. Check = and - before inserting new batteries. Q3: No sound or quiet sound is heard from the speaker while playing back. [. . . ]