User manual OMRON CX-DRIVE 06-2007

[. . . ] D-EV2 CX-Drive OPERATION MANUAL CXONE-ALD-EV2 CX-Drive Operation Manual Revised June 2007 iv Notice: OMRON products are manufactured for use according to proper procedures by a qualified operator and only for the purposes described in this manual. The following conventions are used to indicate and classify precautions in this manual. Always heed the information provided with them. [. . . ] (The commercially available products listed below can also be used. ) For 3G3MV-series Inverters: The CS1W-CIF31 cannot be used. Use the commercially available products listed below. Commercially Available USB-Serial Conversion Cables BHS-US01/GP manufactured by Buffalo USB-CVRS9 manufactured by Sanwa The commercially available USB-serial converters have been successfully tested for OMRON Inverters but operation may be unstable in some operating environments (mainly depending on the ambient temperature, humidity, and noise). The functions, performance, and reliability of these converters may not be as specified under all possible conditions. Check the warranty information from the manufacturer. 10 Overall Operating Procedure Section 1-4 1-4 1-4-1 No. 1 2 Overall Operating Procedure Inverters Operations Refer to the CX-One Ver. Install the CX-Server and CX-Drive from the CXOne. Connect the CX-Drive (computer) to the drive (Inverter or Servo) using one of the system configurations. --Connect the drive to the computer. 3 4 Create a new drive Method 1 file. Detect the drives connected online automatically and create drive file for the desired drive. Method 2 Select Inverter as the drive Create a new drive type and then select one of file on the computer the following series. · 3G3JV · 3G3MV · 3G3RV (See note. ) Select one of the following connection types. · Direct · Via PLC (SCU/SCB) · Via PLC (DeviceNet) Select Program - OMRON - CX-One CX-Drive - CX-Drive from the Windows Start Menu. Select File - Autodetect from the menu bar. Select File - New from the menu bar and then select the drive type in the New Drive Dialog Box. Note For version 1 of the 3G3RV, click the Settings Button and select -V1 for the Specification. Select the connection type in the New Drive Dialog Box. 5 Edit the parameters. Tune and test operation. Edit the parameters for the Inverter. Edit parameters in numeric order or by functional category. ----Test Run Perform the following: Forward/reverse operation, stopping, frequency references, acceleration/ deceleration, S-curve display, and dwelling. In the Workspace, double-click Parameter edit and then the required categories in the drive file. Select Drive - Work Online from the menu bar. Select Drive - Transfer - To drive from the menu bar. [. . . ] The following window will be displayed. : Inverter : Servo "Offline" or "online" displayed after the drive name. Click to display lower folder. Click at the left of the drive name to display the following tree. 29 Editing Drive Files Section 2-4 2-4-1 Editing Parameters The parameters for each drive (an Inverter or Servo) can be edited under the parameter numbers. Parameter Editor: Numeric Order Double-click Parameter Editor to open the Parameter Editor Window in numeric order. Select and set each parameter. Double-click. Select or input each parameter value. All parameters displayed in numeric order. Parameter Editor in Functional Categories Double-click the category folder to open the Categorized Parameter Editor Window. Select and set each parameter. Double-click. Select or input each parameter value. Comparing Drive and Parameter Data The comparison operation uploads drive parameters without changing parameter values in the file data. The Parameter Editor Window shows both the drive file and the file data at the same time, and indicates the differences. [. . . ]