User manual OMRON F3C-AL DATASHEET

[. . . ] (residual voltage: 2 V max. ) NPN open collector output type, Light-ON/Dark-ON cable connection selectable Operation and reset: 10 ms max. 6-turn adjuster Incandescent lamp/Sunlight: 5, 000 lux max. Operating: 0°C to 50°C, Storage: -25°C to 60°C (with no icing or condensation) Operating/Storage: 35% to 85%RH (with no condensation) 20 M min. [. . . ] The green LED displays two stability conditions: 1. Output stable OFF (red LED off) Best performance can be achieved if the sensing object is located closer than -10 % of the setting distance or the shiny background is fixed +10 % behind the switching position. A-182 Standard Photoelectric Sensors Precautions Safety Precaution Laser beam!Laser protection class 2 Do not look into the laser beam. Pay attention to the accident prevention regulations and the laser protection class. Avoid any indirect or direct radiation of reflected or emitted laser light! Laser safety The laser safeguards have been stipulated for laser equipment in and outside Japan. The following gives brief description for use in Japan. The JIS C6802 Standard stipulates safety preventives that must be taken by the user according to the laser product class. (The outline is given in the following table. ) User's Requirements Class Item Class 1 Class 2 Class 3A Class 3B 3B* Class 4 3B Connect the remote interlock of the laser beam to the emergency main interlock, the interlock of the room, or the interlock of the door. LASER LIGHT DO NOT LOOK DIRECTLY INTO THE BEAM!LASER PROTECTION CLASS 2 Pout < 1mW 670nm For use in Japan, change the above label for the one that meets the JIS Standards. Using remote interlock Not required Key control Not required Do not keep the key in the lock when the laser beam is not used. Used to protect people from accidental radiation by the laser beam. Post a proper warning sign on the door to the room where laser beam equipment is installed. Beam breaker or attenuator Not required Handling Instructions F3C radiates a visible-light laser. Use F3C so that the light path of the laser beam is terminated. If there is a mirror-smooth reflector in the light path, confine the beam away from the reflected light path. If F3C must be used with the light path open, avoid placing the light path on the eye level. Correct Use Design Power Reset Time The Photoelectric Sensor is ready to sense an object in 300 ms after power-on. Therefore, use it 300 ms after power-on. If the load and Sensor are connected to different power supplies, always switch on power for the Sensor first. Wiring Considerations Load short-circuit protection · The F3C-AL has load short-circuit protection. If a load shortcircuit or like has occurred, the output turns OFF. [. . . ] The laser system must be operated by only properly trained people. * 5 mW or less in the visible range Classification of F3C Class 2 Handle laser equipment in accordance with the following precautions. · Do not disassemble the product. Doing so will release the laser beam to wander around. [. . . ]