User manual OMRON NS-NSDC1V6

[. . . ] V074-E1-07 NS-Series NS-NSDC1-V6 NS-Designer OPERATION MANUAL Notice: OMRON products are manufactured for use according to proper procedures by a qualified operator and only for the purposes described in this manual. The following conventions are used to indicate and classify precautions in this manual. Always heed the information provided with them. Failure to heed precautions can result in injury to people or damage to property. DANGER Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. [. . . ] Set the amount of time after which the screen saver will start up. The time can be set to between 1 and 255 (unit: s). Set whether to enable or disable changing monitor values for addresses displayed on the device monitor screen on the PT. Disable: Monitor value cannot be changed. 7-1 Section 7 System Settings NS-Designer Operation Manual No. 6 Setting Prioritize notification of ON/OFF Button Details Select to prioritize notification of ON/OFF Button notification. 7-1 Settings 7-1-3 Initial Click the Initial Tab. 1 2 3 4 5 1 2 Setting Initial Screen System Memory $SB Allocation Address 3 4 5 $SW Allocation Address Options $SB, $SW Update Cycle Intervals of RUN Signal (Pulse) System Memory List Button Memory Card Free Space Check Flag Details Select the initial screen to be displayed when the PT starts operation. Set the addresses where system memory is allocated. System bit memory can be allocated in the PLC (host) memory area or in $B. When $SB is allocated as host memory, the bit number is not set. A total of 53 bits of bit memory starting from the specified address will be used as system memory. Example: If Serial A is set to DM 00000, the correspondence with $SB is as follows: $SB0 Serial A: DM 00000. 00 $SB1 Serial A: DM 00000. 01 to $SB52 Serial A: DM 00003. 04 System word memory can be allocated in the PLC (host) memory area or in $W. A total of 39 words of word memory starting from the specified address are used as system memory. Set the system memory update cycle and RUN signal (pulse) interval. The cycle can be set to between 1 and 256. Set the communications interval for writing RUN signals. The interval can be set to between 1 and 256. Click the System Memory List Button to display the System Memory List. Set the amount of free space on the Memory Card for which to issue an alarm. If the free space on the Memory Card inserted in the PT is at or below the amount of free space set here, $SB48 will turn ON. 7-2 Section 7 System Settings NS-Designer Operation Manual 7-1 Settings Reference Reference Set internal memory for both $SB and $SW allocation addresses or set the same host address for both for them. Example $SB: Serial A: 00000 $SW: Serial A: DM 00000 Set the same host name (Serial A) for both $SB and $SW. TIM, CNT, TK, TU, and CU cannot be allocated for $SB. TK, TU, and CU cannot be allocated for $SW. Refer to 2-4 System Memory in the NS Series Programming Manual for details on the system memory. [. . . ] 5. X Supported Supported Supported Supported Supported Not supported Not supported System Program Ver. 6. 0 Supported Supported Supported Supported Supported Supported Not supported System Program Ver. 6. 2 Supported Supported Supported Supported Supported Supported Supported Screen data version: Ver. 6. 2 A-31 Appendices Appendix 9 Converting Data between Different Versions of NS-series Products NS-Designer Operation Manual NS-Designer and Screen Data Version The versions of screen data that can be read and created depend on the NS-Designer version. [. . . ]