User manual ONE FOR ALL SV-9520

[. . . ] Push the battery door upwards and lift it up to remove it. Match the batteries to the (+) and (­) marks inside the battery case, then insert the batteries. Replace the battery cover by pushing downwards and allowing it to click back into position. - In order to avoid having to re-program your ONE FOR ALL 3 after you remove the batteries, you will need to insert new batteries within 5 minutes. [. . . ] After pressing the DVD mode key, the Playback keys will operate the same functions of your DVD Players. In VCR mode the SP/LP key controls the tape speed function, the AUTO key controls the auto tracking function, just like on your original remote. Teletext Functions: After pressing the TV key, the transport keys (REW, PLAY, FF, PAUSE) are used to operate the main Teletext functions. The symbols below the keys are for Teletext. The text keys are used to access the Teletext functions of your television. Of course, your television must have Teletext capability. TEXT ON: HOLD/STOP: EXPAND: Puts your television in the teletext mode. Stops the television changing text pages. Shows the top half of the teletext page in larger letters. By pressing again, you can see the bottom half of the teletext page enlarged. To return to the regular teletext viewing, press the Expand key again, or press the Text key, depending on your television. Devices can be found under the following keys: Video Recorder Television DVD Player To set up for a second TV, VCR or DVD (See mode re-assignment, Page 9). 6 WWW. ONEFORALL. COM Setting up the ONE FOR ALL 3 Search method --> If your device does not respond to the ONE FOR ALL 3 after you have tried all the codes listed for your brand. --> If your brand is not listed at all. The Search Method allows you to scan through all the codes contained in the memory of the ONE FOR ALL 3. Example: To search for your television code: 1. 3. Switch your television on (not in standby). Press and hold down MAGIC until the ONE FOR ALL 3 red light blinks twice (the red light will blink once then twice). Aim the ONE FOR ALL 3 at your Television. Now press CH+ over and over, until your Television turns off (every time you press the CH+ key the ONE FOR ALL 3 will send out a POWER signal from the next code contained in the memory). You may have to press this key many times (up to 150 times) so please be patient. If you skip past a code, you can go to the previous code(s) by pressing the CH- key. Remember to keep pointing the ONE FOR ALL 3 at your Television while pressing this key. 4. [. . . ] This is useful if you want to set up two of the same devices on the ONE FOR ALL 3. The code can be set up using "Direct code set up" (p. To change a device key, see the three examples below. Example Example Example 1 if you like to program a second TV on the DVD key. [. . . ]