User manual ONKYO R-805TX

[. . . ] English FM STEREO/AM TUNER AMPLIFIER Before using R-805TX Instruction Manual FM STEREO / AM TUNER AMPLIFIER INPUT ENERGY SAVE CD MD CDR/PC LINE/DVD Connections Preparations VOLUME ACOUSTIC PRESENCE FM AM TAPE STANDBY / ON OFF / 1 / 2 / 3 WIDE RANGE AMPLIFIER TECHNOLOGY PHONES DISPLAY MEMORY FM MODE PRESET CLEAR TUNING R-805TX Operation FM STEREO / AM TUNER AMPLIFIER INPUT ENERGY SAVE CD MD CDR LINE/DVD VOLUME ACOUSTIC PRESENCE FM AM TAPE STANDBY / ON OFF / 1 / 2 / 3 PHONES DISPLAY MEMORY FM MODE PRESET CLEAR TUNING WIDE RANGE AMPLIFIER TECHNOLOGY ACCUCLOCK R-805TX Other Information Thank you for purchasing the ONKYO R-805TX FM Stereo/AM Tuner Amplifier. Please read this manual thoroughly before making any connection or turning on the power. Follow these instructions to obtain optimum performance and maximum listening enjoyment from your new R-805TX. Please retain this manual for future reference. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Placing the unit behind such doors may prevent proper remote controller operation. · If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. 21 Setting the Clock The "ACCUCLOCK" features an automatic clock adjusting function automatically sets the clock time by means of RDS broadcast signals. · The "ACCUCLOCK" feature is available only on the European model, and only in areas where RDS broadcasts are available. · Adjust the clock as explained in "Setting the clock manually" on page 24 if you are using U. S. or Canadian models or if you are using the unit in the area where RDS broadcasts are unavailable. · It may take about 5 minutes for the time information to be received and displayed after you plug in the power cord. After the clock is initially set, it will be adjusted periodically when the R-805TX is in Standby mode (all input source indicators are turned off) or in ENERGY SAVE mode (the ENERGY SAVE indicator is lit). Notes on using the "ACCUCLOCK" function: · Make sure that your FM antenna has been properly connected as explained on page 18. It is strongly recommended that you install an outdoor FM antenna since the FM indoor antenna may not receive RDS broadcasts well enough to allow ACCUCLOCK to function properly. · The clock will display the time in a 24 hour cycle. For example, 5:30 pm will be displayed as "17:30". (You can select a 12 hour cycle display setting. For more information, see page 25. ) · If RDS signals cannot be received, no RDS station will be found. Or if an RDS signal is present but the signal is not strong enough to allow the ACCUCLOCK to automatically set the time, "- -:- -" will lit on the display as shown below. (See page 24. ) Setting the clock automatically (European models only) ACCUCLOCK starts operating as soon as the power cord is plugged in. It then searches for an RDS broadcasting station which regularly sends time signals and waits to receive such time information. Do not operate any buttons until the clock setting is complete. The R-805TX retains the clock setting until you unplug the power cord. The following steps describe how to set the clock automatically: 1. "AUTO" flashes slowly on the display. flashes slowly 2. Once an RDS station that sends time signals is detected, the indicator flashes more rapidly. Adjust the clock manually. flashes rapidly 3. Once the time signal is received from the RDS station, "CLOCK ADJUSTED" will scroll on the display. [. . . ] & Canadian models) 87. 5 to 108. 00 MHz (50 kHz steps) (Other area models) AM: 530 to 1710 kHz (10 kHz steps) (U. S. & Canadian models) 522 to 1611 kHz (9 kHz steps) (Other area models) Usable sensitivity FM: Mono 11. 2 dBf, 1. 0 µV (75 ohms IHF) 0. 9 µV (75 ohms DIN) Stereo 17. 2 dBf, 2. 0 µV (75 ohms IHF) 23. 0 µV (75 ohms DIN) AM: 30 µV 50 dB Quieting sensitivity FM: Mono 17. 2 dBf, 2. 0 µV (75 ohms) Stereo 37. 2 dBf, 20. 0 µV (75 ohms) Capture ratio FM: 2. 0 dB Image rejection ratio FM: 40 dB (U. S. & Canadian models) 85 dB (Other area models) AM: 40 dB IF rejection ratio FM: 90 dB AM: 40 dB Signal to noise ratio FM: Mono 73 dB, IHF Stereo 67 dB, IHF AM: 40 dB Selectivity FM: 50 dB DIN (±300 kHz at 40 kHz Devi. ) AM Suppression Ratio 50 dB Harmonic distortion FM: Mono 0. 2% Stereo 0. 3% AM: 0. 7 % Frequency response FM: 30 to 15, 000 Hz (±1. 5 dB) Stereo separation FM: 45 dB at 1, 000 Hz 30 dB at 100 to 10, 000 Hz Stereo threshold FM: 17. 2 dBf, 2. 0 µV (75 ohms) 46 General Clock precision monthly error: +/-30 seconds (at 25 degrees Celsius) Power supply AC 120 V, 60 Hz AC 230-240 V, 50 Hz Power consumption 61 W (120 V, 60 Hz) 54 W (230-240 V, 50 Hz) Dimensions (W X H X D) 205 X 91 X 302 mm 8-1/16" X 3-9/16" X 11-7/8" Weight 3. 4 kg, 7. 5 lbs Specifications and external appearance are subject to change without notice as a result of product improvement. 47 Index to parts and controls Front panel For more information about buttons, turn to the page number in the brackets [ ]. STANDBY/ON button [20, 40, 42] ENERGY SAVE indicator [20] ENERGY SAVE button [20] Remote control sensor [21] Input source indicators [26, 29] INPUT selector [26, 29~32] ACOUSTIC PRESENCE button [27] VOLUME control [26] FM STEREO / AM TUNER AMPLIFIER INPUT ENERGY SAVE CD MD CDR LINE/DVD VOLUME ACOUSTIC PRESENCE FM AM TAPE STANDBY / ON OFF / 1 / 2 / 3 PHONES DISPLAY MEMORY FM MODE PRESET CLEAR TUNING WIDE RANGE AMPLIFIER TECHNOLOGY ACCUCLOCK R-805TX CLEAR or FM MODE button [32, 35] MEMORY button [30~35] PHONES jack [28] DISPLAY button [33~36] PRESET ® buttons [31~33, 35] TUNING buttons [30~32] European models front panel shown. Display RDS indicator (non-U. S. , non-Canadian models only) AM/PM indicator Tuning indicator STEREO indicator MEMORY indicator AUTO/MONO indicator TIMER W. DAY W. END MEMORY REC SLEEP AUTO MONO AM PM RDS STEREO MIN MUTING kHz MHz Timer setting indicators Multi display Frequency indicators MUTING indicator Sleep time indicator 48 Remote controller · You can control the other -connected components with the supplied remote controller. [. . . ]