User manual ONKYO TX-866

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safeguards 1. Read Instructions ­ All the safety and operating instructions should be read before the appliance is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. [. . . ] Start recording at the recording component as desired. To confirm the settings, press the REC OUT button. The current settings will appear for 8 seconds in the front display. Notes: · If you change the input source during recording, you will record the signals from the newly selected input source. · You cannot record the surround effects. · Digital signals input to the DIGITAL INPUT (COAX) and DIGITAL INPUT (OPT) inputs will be output to the DIGITAL OUTPUT (OPT) output. However, MP3, WMA, WAV, and other music formats played using Net Audio are only output as analog audio. · Digital input signals are only output to the digital outputs and analog input signals are only output from the analog outputs. There is no conversion from digital to analog or vice versa. When connecting CD players and other digital components, do not connect only the digital terminals, but the analog ones as well. · There are some restrictions on recording digital signals. After pressing the ZONE 2 button, you must press an input source button within 8 seconds. The indicator above the input source button lights green. In this condition, even if you change the input source for the main zone, the input source for the remote zone (Zone 2) will not change. Ex. : When the CD button is pressed. To select the same source for the remote zone that is selected for the main zone, press the ZONE 2 button again until "Zone2Sel:SOURCE" appears in the display. In this condition, if you change the input source for the main zone, the input source for the remote zone (Zone 2) will change as well. When "Zone2Sel:Off" is displayed, the output to the remote zone is turned off. Notes: · If a sleep time is set with the SLEEP button, the output to the remote zone will also turn off when the sleep time elapses. · The ZONE 2 terminal is an analog output. If no sound is heard from the selected input source, check if the component is connected to the analog inputs. · If the REC OUT button is pressed in the main room while someone is using the system in the remote zone, the Zone 2 function will be deactivated and the source will turn off in the remote zone. · If you select FM (or AM) with the TUNER input source buttons when the source for the remote zone (Zone 2) is set to AM (or FM), the output for the remote zone also changes to AM (or FM). · 7. 1-channel playback in the main room is disabled if the Surr Back/Zone 2 setting in the Surr Back/Zone 2 sub-menu of the Hardware Setup Menu is set to "Zone 2. " system · When you are using the remote zone (Zone 2), operation will not work. · When you are using the remote zone (Zone 2), the Pure Audio setting will not work. [. . . ] © Point the remote controller at the remote sensor of the TXNR900/900E (see page 7). · Remote controller is too far from the TX-866/900E. © Operate the remote controller within 16 feet (5 meters) (see page 7). · Remote controller is functioning in a different mode © Press the RCVR MODE button. 79 Troubleshooting guide If one of the messages shown below appears "Not available with headphones use" Operation not allowed because headphones are plugged into the TXNR900/900E. [. . . ]