User manual OPTEX MORSE MDC-16

[. . . ] Purpose : The coupler rotates the turntable. cONTROL PANEL ENGLISH 1 7 2. Roller ring, to be placed in the centre of the oven. Purpose : The roller ring supports the turntable. 3. Turntable, to be placed on the roller ring with the centre fitting to the coupler. [. . . ] (b) Do not place any object between the oven door and front face or allow food or cleaner residues to accumulate on sealing surfaces. Ensure that the door and door sealing surfaces are kept clean by wiping after use first with a damp cloth and then with a soft dry cloth. (c) Do not operate the oven if it is damaged until it has been repaired by a qualified microwave service technician trained by the manufacturer. It is particularly important that the oven door closes properly and that there is no damage to the: (1) Door (bent) (2) Door hinges (broken or loose) (3) door seals and sealing surfaces (d) The oven should not be adjusted or repaired by anyone other than a properly qualified microwave service technician trained by the manufacturer. This product is a Group 2 Class B ISM equipment. The definition of group 2 which contains all ISM equipment in which radio-frequency energy is intentionally generated and/or used in the form of electromagnetic radiation for the treatment of material, and EDM and arc welding equipment. For Class B equipment is equipment suitable for use in domestic establishments and in establishments directly connected to a low voltage power supply network which supplies buildings used for domestic purposes. severe warning signs for cleaning Do not clean the appliance by spraying water directly onto it. Do not use benzene, thinner or alcohol to clean the appliance. - This may result in discoloration, deformation, damage, electric shock or fire. Before cleaning or performing maintenance, unplug the appliance from the wall socket and remove food waste from the door and cooking compartment. - Failure to do so may result in electric shock or fire. For your personal safety, plug the cable into a 3-pin, 230 Volt, 50 Hz, AC earthed socket. If the power cable of this appliance is damaged, it must be replaced by a special cable. Do not install the microwave oven in hot or damp surroundings like next to a traditional oven or radiator. The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven. Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time. 3. Press the ( ) and ( ) buttons to set the minute. 5. Press the button. 11 WHAT TO DO If yOU ARE IN DOUbT OR HAvE A PRObLEm If you have any of the problems listed below try the solutions given. · Airflowaroundthedoorandoutercasing. · Lightreflectionaroundthedoorandoutercasing. · Steamescapingfromaroundthedoororvents. the oven does not start when you Press the · Is the door completely closed? [. . . ] Connect the blue wire to the terminal marked with the letter N or coloured black. 18 WARnInG WARNING : Ensure that the plug and power cord are not damaged before use. If you have any reason to remove the moulded plug from this appliance, immediately remove the fuse and dispose of the plug. Do not connect the plug to a mains socket under any circumstances as there is a danger of electric shock. [. . . ]