User manual OPTICOM NIVD-124 DATASHEET

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. I All the safety and operating instructions must be read before the unit is operated. · · Make sure to switch the power off before you install the DVR. [. . . ] Item Mask Mouse Selection All Area Detection Mask All Area Continue Exit & Save Exit & Discard Description Select to mask the mouse selected area. Select all the images as motion detection area. Cancel all motion detection images on the screen. Cancel setup and exit setup page. 15 4. 3. 2 Sensor Setup Item Alarm Duration(Seconds) Sensor Popup Description Alarm duration time (1~60 seconds). Check the box to Enable/Disable popup screen function for all channels. Drag the white bar or press to adjust Chroma (U) of your camera from value 0 to 255. Drag the white bar or press to adjust Chroma (V) of your camera from value 0 to 255. Drag the white bar or press to adjust Hue of your camera from value 0 to 255. (This function is ineffective in PAL system). Select to adjust audio volume under LIVE mode and recording mode. 4. 6 Account Setup The Account Setup menu is used to provide role-based permission independently for each user (maximum of 4 users) to access the DVR over network. The default admin account is [admin] and password is "123456". Enter to set up e-mail address of sender. Enter to select events to send out E-mail notifications when below circumstances happen: Motion, Sensor and Vloss (Video Loss). Enter to set up e-mail addresses for up to 10 receivers individually. 26 4. 8 PTZ & RS-485 Setup The DVR allows users to control PTZ functions of your camera. To enable PTZ function, the 485 cable should be connected to the RS-485 port of DVR. Item Enable PTZ Protocol PTZ ID Baud Rate RS-485 ID RS-485 Baud Rate Keyboard Reserved. Description Click the box to Enable/Disable PTZ function for each channel. 9600 19200 Select Baud Rate for PTZ from 2400 4800 27 4. 9 System Setup Item DVR Name DVR Location Language Auto-Seq Interval ( Seconds) Remote ID Description The name of DVR will be shown when users login from remote access. The location of DVR will be shown when users login from remote access Click or press to select OSD language. Click or press to set up duration time in seconds for the interval between channels under Auto-Seq mode. After one minute without any action, the DVR will switch to LIVE mode automatically. Auto lock can function differently according to the setting below. Button automatically Auto Lock: The front panel function keys are ineffective only until using the mouse and please re-enter the password again. [. . . ] If disconnected from network, the screen will display" NETWORK DISCONNECT". MAC Address of DVR The capacity of HDD Percentage of space used on HDD. USING means the HDD is now used for recording. GOOD/ BAD means the HDD has a known/ unknown format for the DVR. [. . . ]