User manual ORANGE DIATONIS 420

[. . . ] The telephone is supplied by battery + battery indicator The telephone is supplied by adaptor Tone / Pulse / Grouding switch Important: Only Shaker, Headset and Adaptor with Geemarc reference can be connected to the sockets. 5V type not supplied) with good polarity into the compartment located on the telephone base. Note : Do not use rechargable batteries, do not do not dispose batteries in household waste. Pay attention to your local battery disposal regulations. [. . . ] - On completion of the call, carefully replace the handset in the cradle to release the line. Your DIATONIS 420 allows you to speak "hands free", so that surrounding people could also hear the conversation. Key to speak with your caller key again to release the line. - Await the dial tone and dial required number (it will be dispalyed on the screen while dialing). - On completion of the call carefully replace the handset in the cradle to release the line. You can also use the «hands free» function to make a call: - Press the / key without lifting the handset. - Dial the desired number as soon as you hear the dial tone. - When the person answers you, you can speak hands free. You can adjust the volume using slide buttons (VOLUME) located on the right side of your telephone. - On completion of the call, press the / key to clear the line. Note: To deactivate the «hands free» function during a call, lift the handset. - Press the OK key to confirm the number and enter the name corresponding to entered number. - Select the desired letter by pressing the corresponding key. While typing the name you can use the following table or the letters printed on the keypad to help you. - If the next letter is the same as the previous letter (or located on the same key), press first on the OK key to move and select the desired letter. - Use the X key to delete a wrong letter. - When the name is correct, press the OK key for 3 seconds to confirm the Number and Name storage. Note : If you wish to insert a pause in the stored number, press the key whilst entering (a P will be displayed on the screen). 2 - CREATING AN ENTRY FROM THE INCOMING CALL LIST If you have subscribed to a Caller Idendification Service (CID feature), you have the possibility to create an entry from the incoming call list because each call is stored into the phone book as a CID entry. - Use and keys to select the number that you wish to store in the phone book from incoming calls list. - Press and hold the OK key until the last number digit flashes. You may update the number at this stage. [. . . ] 654321654321 HELEN Note : During the entries review, the screen will display N for a new entry which has not been reviewed. CID FEATURES When a new call is received, the new call LED will flash and the screen displays: This example shows the 9:52 9-09 total number of calls in the 28 01 incoming call list is 28 with TOTAL NEW a new one. To review the new calls, use the When all new calls have 16 : 53 been reviewed, the new call 16-6 28 LED will disappear and the screen will return to idle state after a few seconds. The total number of incoming call entries on the incoming call list will still be displayed on the screen. [. . . ]