User manual OREGON SCIENTIFIC BWR101-E

[. . . ] set the format of the measurement unit. 1 2 set ACQUIRE WEIGHT FROM SCALE 1. select the display unit on scale. RESET lb kg st - lb 2. Note: Beep sound to indicate end of measurement. 10 4. [. . . ] match the remote display unit with the scale. Note: a) beep sound to indicate the matching is activated. b) check the reading on scale and remote display unit . after changing batteries of the scale, repeat step B-1 & B-2. after changing batteries of the remote display unit, set the clock only. E. replace all batteries when appears on the scale. F. replace battery when for scale or for remote display unit appears on remote display unit. G. memory stored in remote display unit will not be ereased after changing batteries. if there exist irregularity in weighing, press reset on the scale and then repeat step B-1 & B-2. Note: a) place a blunt stylus into the slot to press be reset. b) after reset please wait for few seconds for the scale to self-calibrate. allow the scale to settle for around 30 min if there is a sudden change in embient environment . from an air conditioned room to an open area. If not disposed of properly, batteries can be harmful. Protect the environment by taking exhausted batteries to authorized disposal stations. To extend battery life, when battery power is low, replace all the batteries. TROUBLE SHOOTING Symptom 1. [. . . ] avoid from abrasive or corrosive cleaning agent CL 6 GB RR GB EC-DECLARATION OF CONFORMITY This product contains the approved transmitter module TX 01 and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directives, if used for its intended use and that the following standard(s) has/have been applied: Efficient use of radio frequency spectrum (Article 3. 2 of the R&TTE Directive) applied standard(s) Electromagnetic compatibility (Article 3. 1. b of the R&TTE Directive) applied standard(s) ETS 300 683:1997 EN 300 220-1(2, 3):1997 Safety of information technology equipment (Article 3. 1. a of the R&TTE directive) applied standard(s) EN 60950:1997 Additional information: The product therefore conforms with the Low Voltage Directive 73/23/EC, the EMC Directive 89/336/EC and R&TTE Directive 1999/5/EC (appendix II) and carries the respective CE marking. VS-Villingen / Germany Gerhard Preis August 2001 EC representative of manufacturer RTTE Compliant Countries : All EU countries, Switzerland CH And Norway N 7 GB Legend: Key```` key - Press - Press and hold - Flashing F Légende: Key key - Key Appuyer - Key Appuyer et maintenir appuyer - Clignotant D Legende: Key key - Betätigen - Gedrückt halten - Blinkt I Legenda: Key key - Premere il tasto - Premere il tasto e tenerlo premuto - Flashing lampeggiante ES Leyenda: Key key - Pulsar - Pulsar y mantener oprimido - Parpadeando P Legenda: Key key - Pressione - Pressione e segure - Intermitente 8 GB GB NOTE FOR THE USER · · Please read the manual carefully before use. The scale will calibrate automatically to provide accurate measurement when the scale is placed on the ground. Message: , will be displayed on the scale to indicate the calibration is in process. [. . . ]