User manual OREGON SCIENTIFIC RAR621-EASY MULTI CHANNEL THERMOMETER

[. . . ] 7 Table Stand or Wall Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Remote Sensor (THN122N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Setup Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Data Transmission . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Seconds or weekday 8 9 4 5 10 5 RAR621 English R4 OP Black 5 8/18/04, 5:29 PM EN EN REMOTE SENSOR (THN122N) 1 1 2 3 4 1. Battery compartment (Battery compartment cover not shown) 6 RAR621 English R4 OP Black 6 8/18/04, 5:29 PM GETTING STARTED BATTERIES Batteries are supplied with this product: Main unit Remote unit 2 x UM-4 (AAA) 1. 5V batteries 2 x UM-4 (AAA) 1. 5V batteries UNIT Main Remote LOCATION Indoor Temperature Area Outdoor Temperature Area CHANGE SETTINGS To change, time, calendar and language settings: NOTE It is recommended that you use alkaline batteries with this product for longer performance. Insert batteries before first use, matching the polarity (+ and -) as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press and hold MODE for 2 seconds to enter setting mode. Press setting you want quickly, press and hold or ). TABLE STAND OR WALL MOUNT Use the stand on the back of the main unit / remote sensor, or mount it on a wall with a nail. Attaching the Table Stand NOTE Do not use rechargeable batteries. 7 RAR621 English R4 OP Black 7 8/18/04, 5:29 PM EN EN Installing the Wall Mount 3. The switch is located in the battery compartment. Then, press and hold MEM and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Sensor Data Transmission section for more information. ) 5. Close the remote sensor battery compartment. Secure the sensor in the desired location using the wall mount or table stand. Using the stand or wall mount REMOTE SENSOR (THN122N) This product is shipped with a THN122N Thermometer Sensor that collects Temperature data. Data can be collected from up to 3 sensors. Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment. If you are using more than one sensor, select a different channel for each sensor. 8 RAR621 English R4 OP Black 8 8/18/04, 5:29 PM For best results: · Insert the batteries and select the channel before you mount the sensor. · Place the sensor out of direct sunlight and moisture. · Do not place the sensor more than 30 meters (98 feet) from the main (indoor) unit. [. . . ] · Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity. · Do not tamper with the internal components. · Do not mix new and old batteries or batteries of different types. · Do not use rechargeable batteries with this product. [. . . ]