User manual OREGON EW93

[. . . ] Press and hold it for 2 seconds to view the channels automatically. In normal time mode, press it once to enter the normal time setting mode. During the reception period, press and hold it for 3 seconds to stop the reception. Press it once to turn on the backlight and display the alarm time for 5 seconds. [. . . ] Press "SET CLOCK" key to save and exit the setting mode. The wave segment flashing means time signals are being received. The signal quality could be classified into 3 types: The unit will automatically search for the time signal at 2:00 (3:00 or 4:00 is also available if the signal is not received at 2:00), 8:00, 14:00 and 20:00 each day. Always place the unit away from interfering 6 Press "SET ALARM" key to save and exit the setting mode. During the setting period, press and hold "+/ CHANNEL" or "-/MIN. " key to speed up the change of settings. Through "+/-23 hours time difference" setting, the precise time of another area will be shown. The alarm will be automatically turned on when you set the alarm time. During the alarm time setting period, press and hold "+/CHANNEL" or "-/MIN. " key to speed up the change of settings. In normal time mode, press "SET ALARM" key once to enter the alarm time setting mode. Press "ALARM ON/OFF" key to turn the alarm off and activate it again after 24 hours. If no key is pressed within 120 seconds, the alarm will be turned off and be activated again after 24 hours. Relocate the clock or sensor in other positions to try out where your clock receives the signals best. It will forecast after 12 hours of weather within a 3050km (19-31 miles) radius using different icons. 4ºF), the ice alert indicator light will be turned on and flash. For the sensor, place the screw on the desired wall and hang the sensor by the recessed hole in the back of it or simply place it on the desktop. For the main unit, you can just place it on the table by itself. If the low battery indicator " " displays beside the outdoor temperature, it means that the battery power of sensor is not enough, and you should replace with 2 AAA size batteries at once. While if the low battery indicator " " displays beside the indoor temperature, it indicates that you should replace batteries of the main unit with 2 new AA size batteries. This product is engineered to give you years of satisfactory service if you handle it carefully. Here are a few precautions: · do not cover the ventilation holes. [. . . ] NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]