User manual OVISLINK WMU-6500FS

[. . . ] WMU-6500FS 3. 5" Wireless AP Storage User's Manual 1 Copyright The contents of this publication may not be reproduced in any part or as a whole, stored, transcribed in an information retrieval system, translated into any language, or transmitted in any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without the prior written permission. Trademarks All products, company, brand names are trademarks or registered trademarks of their respective companies. They are used for identification purpose only. Specifications are subject to be changed without prior notice. [. . . ] DCHP Mode: The default mode is "Auto" Client: If you have a DHCP server on the network, set this option to receive an automatic IP address and subnet mask assignment. Server: The AirLive WMU-6500FS will become a DHCP server on the network. Auto: Select this option to let AirLive WMU-6500FS send out a DCHP request during boot up. If you have another DHCP server on the network, the AirLive WMU-6500FS will receive an automatic IP address and subnet mask assignment. If there is no DHCP server on the network, the AirLive WMU-6500FS will become a DHCP server on the network. Static: You can manually configure the IP address and subnet mask of AirLive WMU-6500FS. Server Settings: (This information would be used when you choose Server mode or Static mode. ) Subnet Mask: subnet mask of your network. IP Pool: decide the IP address range that DHCP server will offer. Primary DNS / Secondary DNS: This feature allows you to assign DNS Servers. You could get this information from your ISP. Gateway: The gateway IP address would be the IP address of an alternate gateway. If you do not know how to setup the gateway, please contact your network administrator or ISP. Client List: When AirLive WMU-6500FS is as a DHCP server, here will show some information of DHCP client. Fixed Mapping: DHCP server can assign the same IP address to a certain "MAC address". 3. 2. 2 Wireless Setting Select the Wireless option in the Network Settings page. 28 AirLive WMU-6500FS User's Manual Following information will let you know the current wireless operation status. Basic Settings: allow you to enable or disable wireless function. Advanced Settings: the AirLive WMU-6500FS provides four wireless modes to select. Please refer to the following section to check details of each wireless mode separately. Choose the wireless mode you need, and click "Next" button to setup detail items. 3. 2. 2. 1 Wireless AP only When you are in the AP Only mode, you can setup the basic wireless functions as below. Wireless AP Setting: 29 AirLive WMU-6500FS User's Manual Channel: choose the radio channel number. The default channel of AirLive WMU-6500FS is "1". Please DO NOT set the same channel with your existed wireless network. SSID: the SSID identifies a specific wireless LAN. Before associating with a particular wireless LAN, a station must have the same SSID as the access point. The default SSID setting is "airlive". [. . . ] If choose to use smart card or the certificate as the EAP type, we select to use certificate on this computer. We will change EAP type to fit the variable test condition. 63 AirLive WMU-6500FS User's Manual Figure 2: Enable IEEE 802. 1X access control Windows 2000 RADIUS server Authentication testing: 1. (PC2 follows the same test procedures. ) 2. Download and install the certificate on PC1. [. . . ]