User manual PACKARD BELL EASYNOTE MX37-S-200 EASYNOTE F02 (FREEDOS) QUICK START & TROUBLESHOOTING GUIDE

[. . . ] See the illustrations at the start of this guide for setup instructions. If your computer has been stored or transported in a cold or damp environment, allow it to warm to room temperature before turning it on. Allow the battery to fully charge: Charging: LED = On Charged: LED = Off 4. Briefly press the power button to turn on your computer. Please read the rest of this Quick Start & Troubleshooting Guide to get to know your computer and troubleshoot in case you encounter a problem. may be reproduced or transmitted, in any form or by any means, whether electronic, chemical, manual or otherwise, including but not limited to photocopying, recording, or information storage and retrieval systems, for any purpose without prior written permission of Packard Bell B. V. Copyright Notice Packard Bell Quick Start & Troubleshooting Guide. [. . . ] If one video port does not work, then please try the other. The number of items available will depend on your computer's configuration. Test the power socket: 1. Plug any other electrical device on the wall socket and check if it works. If it does not, your wall socket is probably faulty. Attach the power cord and adapter to your computer. Check if a power or battery LED on the computer is lit. If not, then the power cable or adapter may be faulty. Unplug the computer's power cord from the wall socket, remove the main battery from the computer and press the power button for at least ten seconds. Then release it, connect the power cord again and press the power button to turn on your computer. Before you connect or disconnect the power cord to the back of the computer, please ensure that the power plug is disconnected from the wall outlet. 1. Check that the battery is correctly inserted. Check that the battery is sufficiently charged. Connect the AC adapter and attempt to start the notebook. Disconnect or remove additional devices: A faulty device or main battery can in some situations prevent the computer from starting. Removing additional external devices (such as a printer, a scanner, a modem, etc. ) 1. Disconnect all external devices from your computer. Try to restart your computer and check that it works OK. Usually, you just have to unlock it at the bottom of the base and pull it out. Leave the AC power adaptor plugged to both your computer and the wall socket. Try to switch your computer on and wait for at least 15 minutes. Removing additional internal hardware (such as additional memory, a network card, etc. ) 1. Remove any additional internal device you have installed. [. . . ] 24 TV-Out. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7, 8 U Upgrading Recycling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]