User manual PACKARD BELL EN RS65

[. . . ] All items described in this guide are for illustration purposes only and may not apply to your particular situation. No legal rights or entitlements may be obtained from descriptions made in this manual. NEC Computers International BV reserves the right to revise or make changes or improvements to this product or documentation at any time without obligation to notify any person of such revisions or improvements. In no event shall NEC Computers International BV be liable for any consequential or incidental damages, including but not limited to loss of business profits or any other commercial damages, arising out of the use of this product. [. . . ] Such items could unsuspectingly fall from the top of the set and cause product damage and/ or personal injury. Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer. Power Lines - An outdoor antenna should be located away from power lines. Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. section 810 of the National Electric Cord , ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mats and supporting structure grounding of the lead-in wire to an antennadischarge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode. EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE Note to the CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Objects and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. Please, make sure to connect the power plug to the wall outlet socket after connecting the TV to the adapter!Do not cover the ventilation openings on the back cover. To prevent any unsafe situations, no naked flame sources, such as lighted candles, should be placed on or in the vicinity. Teletext is an information service organized like a magazine, which is provided by some TV stations in addition to regular television broadcasting. Press SIZE repeatedly to display the upper teletext part, the lower teletext part and then to return to the normal. Press again to return to automatic page update. By entering the page number, using digit buttons 0~9. When Teletext information exceeds more than one page, press SUBPAGE first then select the required page number using digit buttons 0~9. Use the cursor left/right to enter a sub menu or enable the function. You can adjust the following items: VIDEO, AUDIO, TV (only in the TV mode), PC and PIP (only in the PC mode) and SETUP. CONTRAST, BRIGHTNESS, COLOUR and TINT are adjusted from 0 to 100. You can adjust picture contrast, brightness, colour, tint and sharpness to the levels you prefer. Note: TINT only works with the NTSC video signal input. When adjusting any item, the sub-OSD will appear like this: VOLUME can be adjusted from 0 to 100. [. . . ] There is a wide range of video and audio equipment that can be connected to your TV. The following connection diagrams show you how to connect them. Remove the back plate at the back of the TV as shown on the illustration. Lay the LCD TV with the screen down on a table, as it will be easier to connect your peripheral equipment. [. . . ]