User manual PACKARD BELL EN TJ68

[. . . ] All the programs are included in your recovery data in a specific partition of your hard disk drive (see page 26 for details). Set up my PC To make it easy, Packard Bell has gathered all important setup steps in one application!Make sure you run Setup my PC to configure your Internet access, antivirus program, Identity card, etc. Packard Bell InfoCentre To discover more about your computer, please make sure you check Packard Bell InfoCentre, the electronic user`s guide installed on your computer (see page 21 for details). [. . . ] Go back to previous restore point with System Restore. System Restore monitors the changes to your computer and automatically creates restore points to revert to a previous time if necessary. It can undo harmful changes to your computer and restore its settings and performance, while saving your personal data files (such as documents, browsing history, drawings, favourites, or e-mails). When you restore your computer you will need to reinstall any programs you installed after the restore point was created. These programs will not work until you do this. system Restore does not uninstall programs. To do this, you should use Add or Remove Programs in the Control Panel. Access System Restore from the Windows desktop If you succeeded in starting your computer using Safe Mode or Last Known Good Configuration: Click on Start > All Programs > Accessories > System Tools > System Restore. Access System Restore during boot-up If you cannot access the Windows desktop: 1. Press the [F11] key upon start-up when the Packard Bell logo appears. You can use System Restore to: Restore your computer to an earlier time This option will return to your computer to how it was on an earlier date, without affecting your personal documents or e-mails (it will not restore lost documents either). Click on Start > Help and Support Center > Keep your computer up-to-date with Windows Update. Select Scan for updates and Yes when prompted to install any required software or device drivers. Update your system files using Windows Update Did you install new hardware? When you install a new hardware device, Windows usually detects it automatically and copies the appropriate files (drivers) to your computer to make it work. This process modifies the system files and can sometimes generate conflicts within Windows. This allows you to view the status of your hardware devices. " signs in front of a device name, going back to a previous version of that driver may help. It can undo harmful changes to your computer and restore its settings and performance, while saving your personal data files (such as documents, browsing history, drawings, favourites, or e-mails). Go back to previous restore point with System Restore. System Restore monitors the changes to your computer and automatically creates restore points to revert When your programs run erratically, there are good chances that your operating system may not be functioning correctly. Please also check the recommendations on the previous case (page 42) if the steps below do not help solve your problem. [. . . ] Only Ethernet LAN or RTC modem cable can have length exceeding 3 meters. For Ethernet LAN cable, use FTP shielded cables only (cat 5). Heat Build-up and Portable Computers The AC adapter and the underside of the computer can become hot after prolonged use. Sustained physical contact with either should be avoided. [. . . ]