User manual PALSON DIABOLO PLUS

[. . . ] Operating indicator light Front bumper Infrared signal receiver Automatic charging socket Sensor window Operational buttons Container opening button Front wheel Dirt sensors Battery cover Side cleaning brush Wheels Recharge indicator light Recharge connector Air outlet grill Dirt container Air outlet grill Mop pad Pull bar Rubber roller Floor brush Sterilising UV light Remote control Automatic charger Virtual wall unit Operating indicator light Locking bar Our products are developed to reach the highest standards of quality, functionality and design. We hope you enjoy your new PALSON DIÁBOLO PLUS intelligent robotic vacuum cleaner. This product may only be disassembled, maintained or changed by PALSON-appointed technicians; failure to observe this warning could result in fire, electric shock or personal injury. Do not touch the device's high voltage power cable with your hands as you could suffer an electric shock. [. . . ] For optimum cleaning, frequently remove built-up hair and dust from the rubber and floor rollers. clean any dust build-up on the air intake. Remove waste paper or dust directly using the dust brush. Carefully rotate the brush and cut out any built-up hair, threads or other entangled objects using scissors or pull them out by hand. The main brush and rubber roller can be cleaned following the installation and dismantling section. Figure 5 figure 6 Push the locking bar backwards and lift the cover with your right thumb; then lift the central cleaning brush using your left hand. Insert the main brush and the floor brush into their corresponding holes before closing the cover. Loosen the screw in the left/right wheel using a screwdriver. Remove the left/right wheel and clean it with the brush (see figure 2). Fit the left/right wheel in its original position and tighten the screws during installation. Remove the front wheel using a tool for leverage and clean it. Fit and press the front wheel into its position to reinstall. Make sure the positive and negative electrodes are correctly aligned, otherwise you could damage the device. Remove the battery if you do not plan to use the device for a long period time. Make sure the positive and negative electrodes are correctly aligned, otherwise you could damage the device. Remove the batteries if you do not plan to use the device for a long period time. Transmission signal Day display Continuous cleaning Start cleaning Day display Time/error display Error display Slow clean Fast clean Clean the sensor and the transparent infrared window using a soft cloth. The wall dirt sensor is located on the front of the robot, while the floor sensor and the transparent infrared window are located on the bottom. Keep the transparent window clean to ensure optimum performance. " " On Sunday, Start/Stop Monday/UV Tuesday/time setting Wednesday/charge Thursday/timer Friday/fast cleaning Saturday/Automatic cleaning after full charge All days of the week/slow cleaning Order confirmation Forward Backwards Turn left Turn right Control panel instructions for use and operating mode The following steps are very important: be sure not to press the wrong buttons on the remote control!You must recheck the code on the remote control or main unit when you change them after first use or during maintenance. Check that the battery in the remote control and in the main unit have sufficient charge; turn off the main unit; press and hold OK on the remote control for more than 4 seconds and then turn on the main unit without releasing the OK button. [. . . ] Run a code test between the remote control and the main unit. Check whether the remote control is within the transmission signal radius. Check to see if the battery is too low; if so, charge the robot directly using the adapter. Make sure there are no obstacles in front of the docking station. [. . . ]