User manual PALSON GEISER

[. . . ] Using other chemical substances or more abrasive products can create serious harm or a lack of safety for the pressure water washer. Do not aim the nozzle towards yourself or other people or animals when you use the washer. Do not use the pressure washer without having fully read the instruction manual. sAFETY INSTRUCTIONS WHEN YOU USE THE PRESSURE WASHER ALWAYS OBSERVE THE ATTACHED DETAILED SAFETY INSTRUCTIONS. [. . . ] All water pressure washers (apart from hot water systems) are designed to function with a cold water supply at least at 50ºC. This water pressure washer can work in an effective manner with water temperatures from 5º - 50ºC. APPLICATIONS Main applications for this device are domestic cleaning tasks such as: - Cars, motorcycles, caravans, boats and bikes. DESCRIPTION Your pressure water washer has been designed for outside use and only for cleaning stone, pottery, stoneware, glass, metal and plastic materials. Before assembly / disassembly of the product, make sure it is unplugged from the outlet. WAND ASSEMBLY (DIAGRAM A) Connect the wand and the pistol (6 and 7) by pushing the bayonet into the nozzle (6) towards the cap of the pistol (7) and mounting it in position (turning it clockwise until its position is blocked). Assembly must be carried out before using the pressure water washer. Be sure that both parts are firmly connected with each other. Otherwise, the wand could come off the pistol. Always remove or replace parts while the pressure water washer is disconnected and unplugged from outlet power. wATER OUTLET CONNECTION (DIAGRAM B) Screw the high pressure hose (5) in the water outlet (4). Be sure the connector is firmly affixed (but not tightened excessively). the minimum supply hose length (not included) advised for maximum user comfort is 5 meters with a 12. 5 (1/2") mm diameter to prevent delay pressure and any potential damage associated with the pressure water washer. Fully open the water faucet, do not activate the pressure water washer yet. Never begin the pressure water washer's operation without supplying connected water. Keep the pistol trigger tightened (7) until all the water pressure air and water begin to flow. As soon as the water begins to flow out from the nozzle continually, release the trigger. Now the pressure water washer has been primed with water. Never try to open the pressure water cleaner's cover during operation. CONNECTION AND DISCONNECTION In order to activate the pressure water cleaner, select "I" in the on/off switch. In order to deactivate the pressure water washer, select "0" in the on/off switch. [. . . ] If the methods indicated cannot solve the problem, bring the water washer, packaging, and stamped warranty to the retail store or Authorized Technical Service to get help. CORRECTION Connect the outlet Try another outlet Replace the extension cord Check that the power supply voltage matches the machine's specifications. activate the machine Restore the grounded protective device. Check the water intake flow volume ­ the hose should fill a bucket with 10 liters in a minute Clean the dirt from the nozzle with a needle and rinse from the front side Clean/replace the nozzle Check the intake water volume Straighten the hose Clean the filter Check if there are hose leaks or blockages Release the safety latch Turned off Grounded protective device (in the case it is used) is shot The pump stops Overheating due to deficient water supply Partially blocked nozzle Blocked/wilted nozzle Insufficient water supply Compressed intake hose Obstructed water filter Blocked intake hose This pistol trigger does not work Safety latch activated There are large pressure fluctuations The machine does not reach operating pressure Thank you for demonstrating your trust in us by choosing one of our products. [. . . ]