User manual PALSON GRECO

[. . . ] Get in contact with the Authorized Technical Service so that they can examine, repair, or fine-tune it. Do not pull the vacuum cleaner or transport it using the cord. Do not stuff the cord under a door or let it go around sharp edges or corners. Do not run over the cord with the appliance. [. . . ] WARNING: Important: If the hose connection, the flexible hose or metal pipe is blocked, turn off the vacuum and remove the obstruction before restarting the unit. If the obstruction takes place at the air inlet, a red light will turn on automatically along with the speed level indicator light. Do not use the vacuum too close to heaters or radiators. Before connecting the plug into the wall outlet, make sure you have dry hands. Before turning on the unit, be sure to remove large or sharp objects that may damage the dust bag or flexible hose. When removing the plug from the wall outlet, pull from the plug, not from the power cord. Do not use the vacuum cleaner without filters. If, while using the vacuum cleaner, you notice a squeaking sound or a reduction in suction power, stop the vacuum cleaner and, after unplugging it, clean all air filters. Note: In order to avoid risks, if the power cord is damaged, it must be replaced by the manufacturer, by authorized service personnel, or by a qualified individual. USE AND FUNCTIONING Assembling the vacuum cleaner Note: Always remove the plug from the wall outlet before you install or remove accessories. To attach the flexible vacuum hose, connect the air inlet duct and press it until it clicks, which will indicate that the flexible hose has been fixed in place. To attach the telescopic metal tube to the handle of the flexible hose, put pressure on the metal tube until the handle goes into the telescopic metal tube. To attach the floor brush to the metal tube, put pressure on the metal tube connected to the brush. adjust the metal tube to the desired length. VARIABLE SUCTION CONTROL Note: Once all accessories are set in place, unwind a sufficient length of cord and insert the plug into the wall outlet. A yellow mark on the power cord shows the ideal length. Do not pull the cord out beyond the red mark. Press the on / off switch located on the unit to turn on the vacuum cleaner. To pull in the power cord, press the cord rewind button with one hand and guide the cord with the other hand to ensure that it does not whip back, which may cause damage or injury. To control the vacuum cleaner suction power, press the power control (+/-). MOTOR THERMOSTAT Important: This motor comes equipped with thermostat protection. If, for whatever reason, the vacuum overheats, the thermostat will automatically shut off the unit. [. . . ] Important: All filters should be checked regularly for signs of deterioration, preferably after every cleaning task. The filters should be replaced immediately if any damage occurs. Always disconnect the vacuum cleaner from the electrical outlet before checking the filters. Thank you for showing your confidence in us by choosing one of our products. [. . . ]