User manual PALSONIC VCR9600

[. . . ] OWNER'S MANUAL VIDEO CASSETTE RECORDER VCR-9600 Type Tested Electrical Safety AS/NZS 3250 Lic 4168 Standards Australia How to Use This Manual Please read this Owner's Manual carefully before using the VCR and store it in a safe place for future reference. This Owner's Manual explains how to use your VCR and, in particular, using the remote control unit keys to control the VCR. Keys on the VCR itself that have the same label as their counterparts on the remote control unit perform exactly the same functions. There is an "Identification of Controls" illustration on the back of this page. [. . . ] To add or change other positions, repeat Steps 3. -5. CHANNEL PRESET POS 01 02 03 04 05 V CH 002 * 022 * 045 101 121 SKIP NO NO NO YES YES CHANNEL PRESET POS CH SKIP 01 045 NO 02 022 YES CHANNEL PRESET POS CH SKIP 01 045 YES 02 022 NO 4. 5. 6. <-- YES: Skipped NO: Not Skipped SELECT =[ V ] ENTER =[>] END =[MENU] Display while a channel is being tuned. E-9 CHANNEL SELECTION Tuning with the V CH 1. Press the OPERATE/TIMER button to turn on the VCR. Press the buttons to select the position number to which the desired channel has been preset. P10 . . Notes If the buttons are pressed and immediately released, the preset position steps up or down and the corresponding channel is tuned. If the buttons are held in for longer than 0. 5 second, the position numbers will keep changing until the button is released. V Buttons Tuning with the Number Buttons (Remote Control Only) For channels preset in single-digit position Press the 0 button, then the corresponding number button (1 to 9) within three seconds. For channels preset in two-digit position 1. First enter the ten's digit with one of the NUMBER buttons 1-9 2. Then enter the one's digit within 3 seconds with the NUMBER buttons 1-9 and 0 . . Notes If you select a position with no assigned channel, it is not valid, and the previous channel will reappear. If you wait more than 3 seconds to enter the second digit, the first digit will disappear and the previous position number will reappear. Even when "SKIP" is set to "NC" on the CHANNEL PRESET Screen (see page 9) it is possible to select channels with the NUMBER Button. Selecting AUX Position The AUX (auxiliary input) position (displayed as "AU") may be selected with the 0/AUX button. When the AUX position is selected, recording from an external A/V source may be performed with the AUDIO/VIDEO socket. Press the 0/AUX button twice to select the AUX position. . E-10 PLAYBACK Basic Operation 1. Insert a cassette tape into the CASSETTE LOADING SLOT. Turn on the TV and select the channel for video viewing. Press the PLAY button to start playback. Picture Control (Video Enhancer) During playback, press the NUMBER button 5 or 6 to obtain desired picture enhancement. To make the picture softer, press the NUMBER button 5. To make the picture sharper press the NUMBER button 6. The enhaticement level is indicated by figures (-9 to 9) on the Multi-display. Auto Rewind System When a tape reaches its end in Playback, Fast Forward or Record mode except OTR and Programme Timer Recording, it will be automatically rewound to its beginning and the unit will be switched to Stop mode. To stop playback: Press the STOP/EJECT button. To rewind a tape in Stop mode: Press the REW button. To advance a tape rapidly in Stop mode: Press the FF button. [. . . ] Leave the VCR with the AC mains cord connected. (It takes aproxmately 2 hours for the VCR to dry out Set the TV channel to the correct one. Fine tune the video channel of the TV set. Check these connections and connect them correctly. [. . . ]