User manual PANASONIC AJ-HRW10G

[. . . ] Operating Instructions Hard Disk Storage Unit Model No. AJ-HRW10G Before operating this product, please read the instructions carefully and save this manual for future use. S0409H0 -M D Printed in Japan ENGLISH VQT2C68 Read this first! CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Declaration of Conformity Model Number: AJ-HRW10G Trade Name: PANASONIC Responsible Party: Panasonic Corporation of North America One Panasonic Way, Secaucus, NJ 07094 Support contact: Panasonic Broadcast & Television Systems Company 1-800-524-1448 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] C Cancel button Return to the main screen without automatic copying. In this mode, the unit detects when a card is inserted. If no other card is inserted within 10 seconds, data is automatically copied from the inserted card to the designated HDD. After copying, it will copy automatically when inserting a new P2 card. · Multiple P2 cards may not be recognized if inserted at the same time. In this case, automatic copying is not performed. · Auto copy will not be executed even when the unit is started or restarted while a P2 is inserted. · The data is not copied automatically if the amount of recordable memory on the HDD is less than that on the P2 card. · If a copied card has been inserted into the HDD while ON is set for the copied card check function (Card Check), auto copy will not be executed. To re-copy an already copied card, press the Copy All button. 23 Copying (continued) Once copying starts in manual or auto copy mode, the sequence of processing is as follows. The copying state and the progress of each card displays on the screen. Confirmation after copying The results of copying can be checked on the copy confirmation screen displayed after copying is finished. A B C A Status displays The meaning of the status indicated is described below. Copying The contents are being copied to this destination. Verifying State in which copying is completed and the data on the HDD is being compared with the data on the P2 card. NS The destination is not selected now. B FINISH button Enter the completion of the copying process. C CANCEL button Cancel copying in progress. · If copying is cancelled before completion, all copied data will be erased. · Copying cannot be canceled while verifying is underway. By pressing the CONFIRM button, the copying is finished, and when the FINISH button on the copy state display screen is pressed, a screen on which to confirm the previewing of the copied data is displayed. If the YES button is pressed on the confirmation screen, the EXPLORE screen which displays the folders and icons on the HDD will appear. If the NO button is pressed instead, the main screen is restored. 24 Checking the clips in P2 card/HDD Open EXPLORE screen, you will find that data in different device displays in different ways. P2 card : Thumbnail A H I HDD : Folder J K L M N O P T B C D E F G Q R S To display the clips on the HDD, double-click the folder for the day when the data was copied. A Device selection button (page 29) Select the device displays in the thumbnail screen. The selected device will be displayed on the button. [. . . ] Copy the folder to your preferred target folder on the computer. Execute the same procedure on all drives of the unit. Using the "P2 Viewer" Select needed clips and copy them to your preferred target folder on the computer, where you have set up the virtual drive. Refer to the P2 viewer's operating instructions for details on operation. For Macintosh Using Finder Double-click folders displayed on the desktop (which represent drives on the unit) to open them. [. . . ]